Yakima KingJoe Trunk Mounted Bike Rack Review
Today we are going to show you part number Y02619 from Yakima. This is their KingJoe 2, two-bike, trunk-mount bicycle rack. It does strap onto the rear of your car and uses six straps to do so. It actually grabs it from the top edge of the trunk lid, the bottom edge of the trunk lid - or, in some cases, around toward underneath the bottom edge of the bumper - the side of the trunk lid itself, usually typically around the tail lights. Now, we are going to show this on a car, but this rack can also be used on SUVs and minivans. The way this adjusts is that this arm here and this arm here pivot from each other if you pull this knob out to the side like that. And the one on the opposite side you can you make it wider for like flat vehicles like on a van or like we had it for a car trunk application. And when you find a position you like, you can just go ahead and put the knob back and give it a little bit of a nudge and it will snap back in position. And the same thing applies for the arms that carry the bikes. Again, pull out the same knob on the interior. Pull it out and give it a little bit of a twist, and you can move it as needed. And when you find a position you like, again, just put the knobs back in. Sometimes you rock it to help it snap in, too, if it does not snap in right off the bat. Let us go ahead and install it on our Dodge Neon here.
Trailer Wiring Harness Installation - 2000 Dodge Neon
This Tow Ready 4 way flat trailer connector is hardwired to the vehicle to provide a trailer connector powering the running lights, turn signals and brake lights on a trailer. This demonstration will show exactly what you will need to do to install the flat four pole trailer connector on a 2000 Dodge Neon. Even if you do not have a Neon the video will provide you with a better idea what will be required for vehicles where the 18002 flat four pole is recommended.
