Weight Distribution Clamp On Chain Hanger Kit by Draw-Tite, Hidden Hitch and Reese
Chain hanger kit simply clamps around trailer frame and is only 2" wide. To tighten chains simply raise the trailer tongue and rear of vehicle with the trailer jack.
- No drilling required
- Includes two (2) brackets - one for each side of trailer tongue
- Includes hardware
- Fits 4", 5" and 6" tall trailer frames
- Width of trailer frame cannot exceed 2-1/4" wide
- Chain hanger brackets measure 2" wide
Note: From the center of the chain hangers to the center of the coupler ball should measure approximately 31"
Typical Installation Instructions
See Larger
