Plug-N-Tow Wiring Connectors provide a no-hassle, quick and easy way to wire
your vehicle.
- Each vehicle specific connector is pre-wired and uses original OEM connectors for water tight protection, a guaranteed fit, and a great look
- No cutting or taping
- 16 gauge wire
- 4-Pole connector includes dust cap
- Each kit includes everything needed to complete a 4-wire flat installation
- Powered converter is included
Subaru Outback connection point is located by removing a 3" x 3" interior access panel behind the driver's side tail lamp housing.
Subaru Forester connection point is located on the passenger side in the spare tire compartment under the floor in the rear of the vehicle.
Can be used with 5-pole, 6-pole or 7-pole adapters.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. tail lights: (8 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Similar to Tow Ready # 118461
Hopkins # 43855, TAP # 33855
This is a custom fit application for the following vehicles.
Use the
HitchHunter(R) to find what fits.
1998 - 2008 Subaru Forester
2008 - 2009 Subaru Outback Wagon All Models, except Sport
2005 - 2007 Subaru Outback Wagon Except Sport
1996 - 2001 Subaru Legacy Outback Wagon
2002 - 2004 Subaru Legacy Outback Wagon, Including H6
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Very easy install on Forester
BIGBX1 from Newnan,GA
5 minute install time,follow the instructions included and you will be ready to roll.