Wiring Harness Installation - 2008 Honda CRV - Video
Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the T-One Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Connector is Equipped with a Circuit Protected Taillight Converter
- Protects itself and the tow vehicle against harmful electrical shorts and mis-wire situations.
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection point is located behind the interior trim panel in the cargo area on the driver's side. The 4-pole trailer connector will be stowed inside the cargo area of the vehicle.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: 1 per side (2.1 amps)
- Max. tail lights: (5 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Plug and play!
Tom from Albany, GA
The product worked perfectly. However, the panel in my vehicle was hard to remove. Once the panel was removed, the electrical plugs matched. all lights worked as they should.
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Good harness
Dave S from Cleveland, OH
Not bad to install, but instructions could be better as far as how to remove the interior panels. No need to drill a hole for the ground wire; there's a body ground nearby that works fine. Wire tucks neatly inside the spare tire compartment, and fits under the tailgate seal when in use.
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
great plug and go harness
Rich D. from Wethersfield, CT
This required disassembly of my left rear trunk area. I also cut the wires to feed them through an access hole near the left side, soldered them back together and taped them up. This was a much cleaner install. This took me about 1 hour to do without rushing
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Great Web Site
Ernest again.. from Eatonton, Georgia
After reading your Instructions I decided to take a chance and install the harness on my CR-V. Tell your customers to pull the rubber trim around the hatch back, its not glued and makes the panel trim easy to grab..Thanks
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
good products. EZ
Buck from Sterling PA
ez installation & much cheaper than a dealer.Thanks.
See Larger
Instructions
