Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the T-One Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Connector is Equipped with a Circuit Protected Modulite
- Protects itself and the tow vehicle against harmful electrical shorts and mis-wire situations. Also draws power for the lights on the trailer directly from the vehicle battery instead of through the vehicle's wiring system.
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection points are located in the trunk or cargo area of the vehicle behind the taillights. T-One harness does include a modulite. Therefore, a wire is run to the front of the vehicle and connected to the battery.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: 1 per side (2.1 amps)
- Max. tail lights: (4.2 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Modulites: Draw-Tite Modulite wiring harnesses reduce the strain on the vehicle wiring system by drawing power for the trailer lights directly from the vehicle battery instead of through the vehicle's wiring system.
This is a custom fit application for the following vehicles.
Use the
HitchHunter(R) to find what fits.
2007 - 2008 Mazda 6 4 Door Sedan
2003 - 2006 Mazda 6 4 Door Sedan and 5 Door Hatchback
2003 - 2003 Mazda 6 4 Door Sedan Only
2007 - 2009 Mazda CX-7 All Models
2007 - 2009 Toyota Camry 4 Dr.
2007 - 2008 Toyota FJ Cruiser
Instructions