Dual Cam Sway Control 6" Frame 26001 : Trailer hitch bike rack and trailer hitches

Clamp On Dual Cam Sway Control

Patented Cam Design
Fully Automatic and Self-Centering
Attaches Directly to Round or Trunnion Spring Bars
- Designed for use on spring bars with the integrated cam design
- Cam adapter is included for straight style round and straight style trunnion spring bars
- 4-1/2" from the end of the spring bars must not exceed 1-1/2" in width or 5/8" in thickness for cam adapter to work
Bolts-On for Easy Installation
Fits 6" Tall Trailer Frames
- Width of frame cannot exceed 2-1/8"

Older style spring bar with straight end.

spring bar with integrated cam or bend on the end

Newer style spring bar with integratec cam.

Note: Sway controls are to be used with Class III and Class IV hitches only. Do not use with Class I or II hitches. Cannot be used with surge brakes.

Dual Cam Sway Control pictured with 7903 Dual Ear Weight Distribution

Unlike the friction sway control, the dual cam approach works to control sway from the start rather than just resisting sway once it has begun. When towing in a straight line, the cams on either side of the trailer A-frame are locked in position. This essentially creates a "rigid" connection between tow vehicle and trailer and minimizes the effects of induced sway caused by high cross-winds or passing vehicles.

Even on fairly sharp curves, the cams usually ride in a locked position. However, when cornering maneuvers are required, the cams automatically slide out of their locked position to permit full radius turns. When the maneuver is short and abrupt, like that encounterd in the event of a sudden swerve, the cams seek a straight-line towing angle that helps the tow vehicle retain control.

The advantage of the dual cam system is its ability to prevent sway in addition to providing resistance against it. The dual cams work to hold down the start of swaying activity while at the same time allowing free and easy vehicle and trailer interaction. Because the dual cams are installed on the trailer, the system does not require adjustment every time the tow vehicle and the trialer are hooked up, unless the hitch wieght or tow vehicle loading change.

Dual Cam Sway Control by Draw-Tite and Reese