Today on our 2013 Honda CRV well be test fitting the Yakima Fatcat 6 Locking Rooftop Ski and Snowboard Carrier, part number y03088. Now to begin our test fit, well take the front carrier, place it over the top of our front crossbar and bring the rubber-coated steel straps around underneath the crossbar and latch them back to the carrier attachment point. Once theyre locked in place on either side, we can then open up the carrier, tighten down the wing nut and clamp it into place. With that our carrier on the front crossbar is now secured. Well now place the rear carrier on top of the rear crossbar and repeating the same procedure clamp it down and then make sure its secured to the rear crossbar. Now with both carriers in place, we can go ahead and load our skis and snowboards.
Today on our 2013 Honda CRV were going to be test fitting the Whispbar Locking Rooftop Ski and Snowboard Carrier, part number wb-300. To begin our test fit, well take our front carrier and place it on our front crossbar. We can go ahead and bring the rubber-coated steel straps around the crossbar, latch them into position, and then lock them in place. We can then open our carrier and tighten it down to our front crossbar by tightening the wing nut located inside. Once we have our front carrier secured to our front crossbar, we can then close the carrier and repeat the same process for the rear. We need to make sure that our rear carrier is lined up with our front carrier.
Today on our 2013 Honda CRV, well be test fitting the Thule Flattop Ski and Snowboard carrier, part number th92725. To begin our test fit, well simply place the front carrier over the front crossbar and bring the rubber coated steel straps around underneath the crossbar and secure it back to the foot of the carrier. We can then use the gray knob to tighten down each strap; we will do this on both sides of the carrier.Now with the front carrier installed we can move to the rear carrier where again, well repeat the same procedure, only this time were going to want to line it up with the front carrier to make it easier to load our skis and snowboard. With the rear carrier installed, were now ready to load our skis and snowboards. Well simply open the carriers using the gray push button on the ends of each carrier and then we can slide the snowboard and ski into position and clamp down the carriers.Just like that were all loaded up and were ready to go. That completes our test fit of the Thule Flattop Ski and Snowboard carrier, part number th92725 on our 2013 Honda CRV..
Do you have a question?
Have a question about the best ski and snowboard racks for your Honda CR-V? click here.