Top 20 Most Popular Ford Expedition Bike Rackschange vehicle

SportRack EZ Hitch Bike Rack Review - 2011 Ford Expedition

Today on our 2011 Ford Expedition, well be test fitting part number a30901, the Sport Rack two bike hitch mounted bike rack with mount cradles for both inch and a quarter and two inch hitches. Now to begin our test fit well slide our bike rack shank with the included adapter into the hitch, line up the hitch pin hole, and install and tighten down our anti-rattle bolt. With our bolt tight our bike rack is secured to the vehicle. Now well go ahead and give you a few measurements, our ground clearance at the bike rack is 23-1/8 inches and from the closet point of the bike rack to the back of the vehicle is 10-1/2 inches. Now well go ahead and unfold the bike rack platform and open our cargo door and as you can see we can gain full access to the cargo area opening our cargo door completely with this bike rack. Were now almost ready to load our bike, all we need to do is make sure that our wheel loop straps are undone and out of the way and that our vertical bar clamp is fully extended.

Swagman XTC2 Wheel Mount Hitch Bike Rack Review - 2011 Ford Expedition

Today on our 2011 Ford Expedition well be test fitting part number S64670. This is the Swagman XTC2 2 Bike Carrier for both 1-1/4 and 2-inch hitches. With our adapter already installed on the shank of the bike rack for the 2-inch hitch were ready to fit it to the vehicle. Well slide the bike rack shank into the hitch, line up the hitch pin hole and install and tighten down our anti-rattle bolt. With our bolt tight, our bike rack is secured to the vehicle. Now well go ahead and give you a few measurements.

Thule Vertex 4 Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Thule Vertex hitch mounted bike carrier, part number TH9029. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about five inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 16 inches of length to the rear of the vehicle with the carriers arms folded down.

Swagman Titan Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Swagman Titan IV hitch mounted bike carrier, part number S63410. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up the hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about 10 inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 23 inches of length to the rear of the vehicle with the carriers arms folded down.

SportRack EZ Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Sportrack II hitch mounted bike carrier, part number A30901. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt, and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about 10 inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 30 inches of length to the rear of the vehicle.

Thule Parkway 2 Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Thule Parkway II hitch mounted bike carrier, part number TH958. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt, and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about three inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 24inches of length the rear of our vehicle.

Thule Hitching Post Pro Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2004 Ford Expedition well be test fitting the Thule Hitching Post Pro hitch mounted bike carrier, part number TH934XTR. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 17 inches of ground clearance and about eight and a half inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 19 inches of length to the rear of the vehicle with the carrier arms folded down.

Thule Apex 4 Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Thule Apex IV hitch mounted bike carrier, part number TH9025. To mount the carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well close the hitch pin through the hitch pin hole and tighten the hand knob at the base of the rack to engage the anti-=rattle device. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about five and a half inches of clearance between the closest part of the vehicle and the closest part of the carrier. Overall weve added about 16 inches of length to the rear of the vehicle with the carriers arms folded down.

Swagman XTC2 Wheel Mount Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Swagman XTC2 hitch mounted bike carrier, part number S64670. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about seven inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 24 inches of length to the rear of the vehicle.

SportRack Escape 3 Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Sportrack Escape III hitch mounted bike carrier, part number A30403. To mount our carrier to the vehicle well want to turn the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about seven inches of clearance between the closest part of the carrier and the closest part of the vehicle. Overall weve added about 15 inches of length to the rear of the vehicle with the carrier arms folded down.

Pro Series Eclipse 4 Hitch Bike Rack Review - 2005 Ford Expedition

Today on our 2005 Ford Expedition well be test fitting the Pro Series Eclipse 4 hitch mounted bike carrier, part number 63124. To mount our carrier to the vehicle well insert the shank of the carrier into the receiver tube of the hitch. Well line up our hitch pin hole, thread in our anti-rattle bolt and tighten it down using a wrench. Next well go over a handful of clearance measurements. Weve got about 18 inches of ground clearance and about six and a half inches of clearance from the closet part of the carrier to the closest part of the vehicle. Overall weve added about 33 inches to the length of our vehicle.

Pro Series Eclipse 4 Hitch Bike Rack Review - 2011 Ford Expedition

Today on our 2011 Ford Expedition, we'll be test fitting the Tow Ready 4 Bike Hitch Mounted Folding Bike Rack, part number 63124. With our vehicle equipped with a 2-inch hitch and our bike rack already pre-assembled, we're ready to go ahead and fit it to the vehicle. We'll begin by inserting the bike rack shank into the hitch. We'll line up the hitch pin hole. We can go ahead and insert our anti-rattle bolt. With our anti-rattle bolt snug, we'll go ahead and tighten it down with a wrench and insert our safety pin.

Swagman Titan Hitch Bike Rack Review - 2011 Ford Expedition

Today on our 2011 Ford Expedition, well be test fitting the Swagman Titan 4-Bike Carrier, product number S63410. With our vehicle already equipped with the 2-inch hitch and our bike rack already preassembled were ready to go ahead and fit it to the vehicle. Well begin by inserting the bike rack shank into the hitch. Well line up the hitch pin hole and go ahead and insert our anti-rattle bolt. With our anti-rattle snug, well go ahead and tighten it up with a wrench and install our safety pin. With our anti-rattle bolt tight and our pin installed our bike rack is secured to the vehicle and were ready to load a bike.At this point, well give you a few measurements.

Thule Apex 4 Hitch Bike Rack Review - 2011 Ford Expedition

All right today in 2011, Ford Expedition. We're going to do a test to the part number TH9025 from Thule. This is Apex 4 bike carrier. Few quick notes what this bicycle carry, they will work with a two-hinge receiver hitch with provided spacer, and also work on inch and quarter receiver hitches, both class one and class two. However, when you use it on a class one receiver hitch, youre limited to just two bikes. Okay.