Top 20 Most Popular Chrysler Town and Country Cargo Carrierschange vehicle

Rola Hitch Cargo Carrier Review - 2010 Chrysler Town and Country

Today on our 2010 Chrysler Town & Country well be test fitting the Rola 23 x 56 Railed Cargo Carrier for 2-inch hitches part number 59502. Now to begin well simply slide the cargo carrier shank into the hitch, line up the hitch pin hole and install our hitch pin. Well then put the clip on the other side of the pin securing our cargo carrier to the vehicle. Well now go ahead and give you a few measurements. From the closest point of our cargo carrier to the back of the vehicle is 6 inches and the cargo carrier itself will add an additional 31-1/2 inches of overall length to the vehicle. Our ground clearance here at the cargo carrier is 14-1/2 inches and our exhaust on this vehicle does exit the passengers side here at the rear bumper.

Pro Series Hitch Cargo Carrier Review - 2010 Chrysler Town and Country

Today on our 2010 Chrysler Town & Country well be test fitting the Pro Series 24x60 Railed Cargo Carrier for 2-inch Hitches part number 63153. Now to begin our test fit, well slide our cargo carrier shank into the hitch, line up the hitch pin hole and install our hitch pin. Well then put our clip on the other side of the pin which will secure our cargo carrier to the vehicle. Well now go ahead and give you a few measurements. From the closest point of the carrier to the back of the vehicle is 6 inches and the carrier will add an additional 32 inches of overall length to the vehicle. Our ground clearance at the back of the cargo carrier is 15 inches and the exhaust on this vehicle does exit the passengers side here at the rear bumper.

Surco Hitch Cargo Carrier Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, well be test fitting the 24x60 cargo carrier for 2-inch hitches from Surco part number 52018. Now all we need to do is insert the cargo carrier shank into the hitch, line up the hitch pinhole and install our hitch pin. Well then put the safety clip on the other side of the pin, which will secure our cargo carrier to the vehicle. Well now go ahead and give you a few measurements. Our ground clearance here at the back of the back cargo carrier is 11 inches. From the closest of the cargo carrier to the back of the vehicle is 1 inches.

Rola Hitch Cargo Carrier Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, well be test fitting the 23x56 rail cargo carrier from Rola part number 59502. Now all we need to do is insert the cargo carrier shank into the hitch, line up the hitch pinhole and install our hitch pin. Well then put the safety clip on the other side of the pin, which will secure our cargo carrier to the vehicle. Well now go ahead and give you a few measurements. Our ground clearance at the back of the back cargo carrier is 15 inches. From the closest of the cargo carrier to the back of the vehicle is 7 inches.

Curt 20x60 Folding Aluminum Cargo Carrier Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, well be test fitting the part number C18100. This is the Curt 20x60 folding aluminum cargo carrier for 2-inch hitches. Now all we need to do is insert the cargo carrier shank into the hitch, line up the hitch pinhole and install our hitch pin. We can then put the clip on the other side of the pin, which will secure our cargo carrier to the vehicle. Well now go ahead and give you a few measurements. With the cargo carrier in the stored position, there approximately one inch of clearance between the carrier itself and the back of the vehicle.

Pro Series Hitch Cargo Carrier Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, we'll be test fitting the 24x60 Railed Cargo Carrier for 2-inch hitches from Pro Series, part number 63153. Now to begin our test fit, we'll slide the cargo carrier shank into the hitch, line up the hitch pin hole and install our hitch pin. We'll then put the safety clip on the other side of the pin which will secure our cargo carrier to the vehicle. We'll now go ahead and give you a few measurements. Our ground clearance at the back of the cargo carrier is 14-1/2 inches. From the closest point of our cargo carrier to the back of the vehicle is 8 inches and this cargo carrier will add an additional 33-1/2 inches of overall length to the vehicle.

Surco Folding Hitch Cargo Carrier Review - 2012 Chrysler Town and Country

Today on our 2012 Chrysler Town and Country we will be test fitting the 24x60 Folding Cargo Carrier part number 52018f made by Surco for 2-inch trailer hitches.Because our vehicle is already equipped with a 2-inch and our cargo basket is already preassembled, were ready to go ahead and fit it into the vehicle. Well start by sliding the shank into the hitch, lining up the hitch pin hole and then inserting the hitch pin with the safety clip. Please not that our cargo basket does have lights on it. This is not included with the cargo basket. With our hitch pin installed and our safety clip in place, our cargo basket is not secured to the vehicle.What wed like to do for you now is to give you a couple of measurements of this cargo basket from the lower most point of the cargo basket to the floor is 10 inches. From the closest point of the cargo basket to the back of the vehicle is 3 inches.

Yakima RocketBox Pro 11 Rooftop Cargo Box Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, well be test fitting the Yakima RocketBox Pro 11 Rooftop Cargo Box at 11 cubic feet in black, part number Y07193. Now to being our test fit, our vehicle already has factory crossbars, so well place the RocketBox on top of the crossbars. Now well need to adjust the clamps to fit our crossbar spread. Well undo the black knobs inside of the box where we can then slide the clamps to their correct location. Now the clamps on our RocketBox are fully extended. Well now slide the box backwards allowing the clamps to go around our factory crossbars.

Yakima RocketBox Pro 14 Rooftop Cargo Box Review - 2013 Chrysler Town and Country

Today on our 2013 Chrysler Town and Country, well be test fitting the Yakima RocketBox Pro 14 Rooftop Cargo Box at 14 cubic feet in black, part number Y07192. Now weve already gone ahead and pre-assembled our RocketBox and made sure that the clamps are undone. We can now place our box on top of our factory crossbars. We can then adjust the clamps as necessary in order to fit the RocketBox to the vehicle correctly. We can then go ahead and tighten down the black knobs. Well then work back and forth on our RocketBox opening the lid on either side to tighten down the red knobs after we have made sure that they are around our factory crossbars. Now with all four red knobs tight our RocketBox is secured to the vehicle and were ready to load it up.

Yakima LoadWarrior Roof Cargo Basket Review - 2010 Chrysler Town and Country

Today on our 2010 Chrysler Town and Country we will be test fitting the Yakima Load Warrior Roof Rack cargo basket. Our vehicle roof rack is already preset to the 30 inches recommended by Yakima for the cargo basket, and our roof rack is already preassembled. Well go ahead and mount it to he vehicle. Well begin by setting the cargo basket on top of the vehicle. Well center it from left to right. Then well attach it using the included hardware.

Thule MOAB Roof Top Cargo Basket Review - 2010 Chrysler Town and Country

Today on our 2010 Chrysler Town and Country, we will be test fitting the Thule M.O.A.B. Roof Top Cargo Carrier, part number TH690. With our roof rack already set for the 28" spread and our cargo basket already preassembled, we're ready to go ahead and mount it to the vehicle. We'll begin by setting the cargo basket on top of the vehicle and will center it from left to right, will then tighten it down using the included hardware with the basket. With our hardware tight and our basket clamped down to the vehicle, we'll go ahead and install the hardware covers. Now that the hardware covers are on, our cargo basket is ready to be loaded and head on down the road.

Rola Roof Cargo Basket Installation - 2010 Chrysler Town and Country

Today on our 2011 Chrysler Town & Country, we will be test fitting the Rola Roof Mounted Cargo Basket, product number 59504. With the crossbars spacing on our vehicle already set to 30 inches and our roof rack already pre-assembled, we're ready to go ahead and mount it to the vehicle. We'll begin by setting the basket on top of the crossbars. We'll then line it up from left to right, at which point we'll then tighten it down using the included hardware. As stated in the instructions, we will put the U-bolt on the underside of the crossbar. We'll then set the bracket over the top lining up the square holes with the rubber grommets in the cargo carrier.

Thule MOAB Roof Top Cargo Basket Review - 2012 Chrysler Town and Country

Today, on our 2012 Chrysler Town and Country, we'll be test fitting the Thule Roof Cargo Carrier, part number TH690. With our factory roof rack preassembled and our cargo carrier preassembled, we are now ready to test fit it on top of the vehicle. We'll began by setting the cargo carrier on top of the roof rack, centering it from left-to-right and then clamping it down using the provided hardware with the cargo carrier. And with our hardware all tightened up, our basket is secured to the roof rack. We'll then cover with the provided hardware covers. And just like that our cargo carrier is secured and ready to be loaded.

Rola Roof Cargo Basket Installation - 2011 Chrysler Town and Country

Today on this 2011 Chrysler Town and Country, we are going to install a Rola Roof Basket using the factory roof rack system. The crossbars are integrated into the side tracks, so we will need to remove them so that we can place them into position. With the crossbars removed from their storage position, we will fold the feet down and mount them into place. We will repeat the same procedure for the rear crossbar. With our factory roof rack system in place, we will need to fit our Rola Cargo Basket. 0:28