Free Shipping on Orders Over $99
Only 21 Hours 56 Minutes Remaining
Thank you so much for the prompt shipment of our cargo carrier. It is exactly as advertised and fits our Class II receiver great. It will make our trip to the beach with two dogs, fishing gear, etc. in our new, smaller SUV less crowded!
Glen Dale, WV
Today on our 2012 Buick Enclave, we will be test fitting the 23 X 51 alluminium cargo carrier by UWS part no. UWS03511. To begin our test fit we will simply slide the cargo carrier shank into the hitch, lign up the hitch pin hole and insert the hitch pin. We can then put the safety pin on the other side of the hitch which will secure it to the vehile. We will go ahead and give you a few measurement at this point from the closes point of the cargo carrier to the back of the vehicle is more an inch. The inside openning measures 20 and 3/8 inches wide by 48 and 1/2 inches long, by 5 and 5/8 high.
Today on our 2012 Buick enclave, we'll be test fitting the curt 20 X 48 cargo carrier part no. C18145. A quick note about this cargo carrier, it will work in both inch and 1/4 and 2 inch hitches using the included space We will slide the cargo carrier shink into the hitch we'll lign up the hitch pin hole and insert our anti retal bolt. We can then tighten it down with a wrench. Once it's tight, our cargo carrier is secured to the vehicle and we can go ahead and load it up. We'll go ahead and give you a few measurements on our cargo carrier, the insert dimentions of our cargo carrier arre 46 and 3/8 inches long by 17 and 1/2 inches wide by 5 and 1/2 inches tall.