Valley Trailer Hitch Receiver with Drawbar - Custom Fit - Class I - 1-1/4"

Valley Trailer Hitch - V59771

Superior engineering and precision testing combine to form a strong, durable vehicle trailer hitch receiver. Unique a-coat provides greater coverage and corrosion protection than a traditional e-coat base. Drawbar, pin and clip included.

Features:

• Custom fit is designed specifically for your vehicle
• Superior engineering includes hands-on and computer-aided design
  • Prototypes are rigorously tested to SAE and Valley in-house standards
  • Precision laser analysis ensures the best fit and craftsmanship
• Fully welded steel provides strength and durability
• Easy, bolt-on installation - no welding required
  • Complete hardware kit and installation instructions included
• Lifetime technical support from the experts at etrailer.com
• Environmentally friendly a-coat base and powder coat finish resist rust
  • Advanced technique and composition offer superior coverage and protection even inside the hitch
• Drawbar, pin and clip included
• Made in USA

Note: Drilling is required for installation of this hitch.

Specs:

• Receiver opening: 1-1/4" x 1-1/4"
• Rating: Class I
  • Maximum gross trailer weight: 2,000 lbs
  • Maximum tongue weight: 200 lbs
• Limited lifetime warranty

etrailer.com Technical Support

At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.

V59771 Valley Class I Trailer Hitch Receiver

This Product Fits The Following Vehicles

2008 - 2010 Honda Accord 2 Door

2008 - 2010 Honda Accord 4 Dr. Sedan

Ask the Experts about this Valley Trailer Hitch
Do you have a question about this Trailer Hitch?

• Valley Trailer Hitch vs Draw Tite Trialer Hitch Appearance for a 2009 Honda Accord V6 Sedan
  
• At this time we have not had the opportunity to install the Valley Trailer Hitch, item # V59771, on a 2009 Honda Accord Sedan, so we do not have pictures. I also checked with Valley and they do not have photos of the installed hitch. This hitch is designed for the 2008 - 2010 Honda Accord vehicles so there are no other vehicle pictures that would be an accurate depiction. All of the trailer hitches available for the Accord will position the receiver at approximately the same point at the rear
  view full answer...


• Is there Drilling Required to Install a Valley Trailer Hitch on a 2008 Honda Accord
  
• You will need to do a little drilling to install this Valley Trailer Hitch Receiver # V59771 on your 2008 Honda Accord. You will need to drill 4 1/2 inch holes into your vehicle. I attached installation instructions for this product for you to check out also that detail the amount of drilling required. To complete your towing setup you may be interested in purchasing the following products: Hitch Ball with 1-7/8 inch diameter # 19256 Tow Ready Custom Fit Vehicle Wiring # 118420 (instruction
  view full answer...