Oldenkamp Hitch Cargo Carrier - RHMC1
Designed for smaller motorcycles - dirtbikes, crotch rockets and small street bikes (up to 750cc). Simply slide in your hitch, load your bike's front tire and you're ready to go. No trailer needed!
Trailer Hitch Mounted Motorcycle Carrier for 1-1/4" Trailer Hitches
Features:
- Designed to carry dirt bikes, crotch rockets, and small street bikes (up to 750 cc)
- Wheel cradle is v-shaped for a better tire hold which also stabilizes the bike while it is being tied down
- Includes 3 built in ratcheting wheel straps (1500 lbs each)
- Caddy has 4 different height settings to accommodate different hitch heights (from 12" to 22" tall)
- Includes metal ramp bracket and fasteners to drive motorcycle front tire into the wheel cage
- Wood to form the ramp must be provided - length of ramp depends on specific application
- Manufactured from structural square tubing
- Rust-resistant powder coat finish
Specs:
- Fits 1-1/4" x 1-1/4" (Class II only) square trailer hitch receivers
- Hitch height must be between 12" and 22" from the ground to the top of the hitch receiver opening
- Will hold bikes that weigh up to 800 lbs
- Capacity will be limited by the trailer hitch
- Will work with 16" - 21" motorcycle tires
- Tire must be less than 5-1/2" wide
Ask the Experts about this Oldenkamp Hitch Cargo Carrier
Do you have a question about this Hitch Cargo Carrier?
- Can the Hitch Mounted Motorcycle Caddy # RHMC1 Transport a Shaft Driven Honda 750
- This Hitch Mounted Motorcycle Caddy # RHMC1 is rated to handle bikes up to 750 cc so it should work well to carry your Honda 750cc motorcycle.
You will need to check with the local transportation laws and regulations to find out if this is a legal way to transport your motorcycle in Canada and every area you plan to travel to with this product.
Also, shaft driven motorcycles can be used with this style of carrier without a problem. You would just need to put your motorcycle in neutral and
view full answer...
- Can the Oldenkamp Hitch Mounted Motorcycle Caddy # RHMC1 be Used in a Class I Receiver
- Oldenkamp states that their Hitch Mounted Motorcycle Caddy is designed for use in Class II receivers only. A Class I receiver has a very low tongue weight capacity, 200 lbs. Exceeding this capacity can cause damage to the hitch or the vehicle that could result in the loss of the towed accessory. Additionally, most of the hitch manufacturers weld or punch a stop into the receivers so that an accessory meant for a Class II receiver will not slide in far enough for the hitch pin holes to line up.
view full answer...
- Does Oldenkamp Motorcycle Caddy RHMC1 Have an Integrated Jack to Raise and Lower Wheel for Loading
- The Oldenkamp Motorcycle Caddy for Class II receivers that you referenced, part # RHMC1 does not have an integrated jack. It does however include a metal ramp bracket that can be used to construct a ramp that would make loading the front wheel much easier for you.
They do offer a model for Class III receivers that has an integrated jack, part # RHMC1SV, but it would not be compatible with the Class II receiver on your Buick LeSabre.
view full answer... 
