Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
15" L x 1-3/8" L x 5/8" D; sealed; waterproof; 2-wire; 3 red LEDs; red lens
Features:
Thin-line ID light bar for over 80" applications - only 5/8" thick.
Features sonically sealed, waterproof lens and housing in a single unit.
Two-wire design includes both lead and ground wires for mounting to all surfaces.
All-weather, molded plastic housing and durable lens protect against corrosion.

Video of Sealed, Over 80", Ultra Thin Line, LED Identification Light Bar, 2 Wire, 3 Diode - Red
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Today we are going to take a look at Optronics sealed over 80 inches, ultra thin line, LED light bar, part number MCL70RB. This light is designed to indicate trucks and trailers that is over 80 inches wide. Its sealed and water proofed, and inside are three LEDs that draw a total of 0.22 amps at 12.8 volts.
Its designed to surface mount on your truck or trailer using mounting holes that are 14 and 1/8ths inches from center to center. There is a lifetime warranty on the LEDs. It also utilizes a two wire system, one wire for power, and another for ground. Next we are going to hook up the light to a power supply so you can see what it looks like when lit up. Well connect the white wire to our ground and the black wire to our power. Next we will turn off the overhead lights so you can see how bright the light is. And that does it for Optronics sealed over 80 inches ultra thin line, LED light bar, part number MCL70RB.
Customers Who Purchased This Trailer Lights Also Bought...
Average Customer Rating: 



4.5 out of 5 stars (2 Customer Reviews)




by: Brad K.02/25/2011
Is this review helpful?
Awesome looking light. These units are slightly shorter than the stop/turn/tail with reflector. It would be nice if they matched or if there was shorter stop/turn/tail with reflector to match it, but only 1/4 inch difference not too bad. Also, the LED circuit board is open on the back side of the light. I will be filling it with silicone or dielectric grease before mounting and then caulking around the mount to make it water tight.7896




by: Bobby S01/21/2011
Is this review helpful?
Great product quality.....Right on time. This is my second order from Etrailer.com> They will be getting my business in the future.5836
Ask the Experts about this Optronics Trailer Lights
Do you have a question about this Trailer Lights?