Trailer D-Ring Tie Down, Bolt On 2-1/2" x 2-3/8" Surface Mount

Brophy Trailer Cargo Control - LRB1

Utility Trailer D-Ring Tie Down

• 1/2" Ring Diameter
• Measures 2-1/2" x 2-3/8" I.D. with 2" Hole
• Capacity: 2,750 Working Load Limit (WLL); 11,000 Minimum Breaking Strength (MBS)

Customers Who Purchased This Trailer Cargo Control Also Bought...

Ask the Experts about this Brophy Trailer Cargo Control
Do you have a question about this Trailer Cargo Control?

• Recommended Way to Install Heavy Steel D-Ring Tie Down to Aluminum Floor of Car Hauler
  
• Using a piece of plywood between the aluminum will not hold up as well because the wood will start to weaken and will rot over time. The best way to install the trailer D-Ring Tie Down Mount, part # LRB1, to the aluminum floor in your car hauler would be to mount it through the frame of the trailer if possible or using a steel backing plate would suffice. It would probably be good to use some sort of gasket material between the aluminum and the steel to prevent any oxidation or reaction betwe
  view full answer...


• What Size Bolts Should be Used to Mount the Trailer D-Ring Tie Down, # LRB1
  
• I went out to the warehouse to measure the square holes in the Trailer D-Ring Tie Down, # LRB1. According to my measurements it will accept bolts no larger than 7/16 inches in diameter. A 3/8 inch bolt would probably be the most ideal size to use.
  view full answer...