Custer Trailer Lights - LEDTLK01-NM
Submersible Tail Light Kit
- Includes:
- 25' of Wire
- 4-Way Flat Connector
- Wiring for both the vehicle and trailer
- License Bracket
- 2 LED Tail Lights
- Hardware
- Dimensions of lights: 5-3/16" (long) x 4-3/4" (wide) x 2-11/16" (deep)
- Limited lifetime warranty
LTLK01-NM Custer Products LED Submersible Trailer Light Kit with Side Markers
Customers Who Purchased This Trailer Lights Also Bought...
Ask the Experts about this Custer Trailer Lights
Do you have a question about this Trailer Lights?
- Dimensions of Submersible LED Trailer Light Kit # LEDTLK01-NM
- The Submersible LED Trailer Light Kit, part #LEDTLK01-NM, is going to be the closest match for you. The lights measure 5-3/16 inches long, 4-3/4 inches wide and 2-11/16 inches deep.
view full answer...
- All LED Lights on Trailer Work Except Running Lights When Hooked To 2008 Chevrolet Silverado
- There are a few possibilities and things you will need to check on your trailer and your vehicle.
You will want to start by checking the ground wires on the lights, make sure each light has a good ground connection to clean metal surface.
Then, you will want to check the wiring on the trailer, start at the 4-way connector and visually inspect the wires for any cut or exposed wiring. If you find cut or exposed wiring where the protective coating on the wiring is missing, you will want to r
view full answer...
- Options to Replace Square Tail Lights with LED lights for Over 80 Inch and Under 80 Inch Trailers
- If your trailer came with the square Peterson lights then you can use the Submersible LED Trailer Light Kit, item # LEDTLK01-NM, that you referred to, or the Submersible, Under 80 inch LED Trailer Light Kit, # TLL9RK.
The Over 80 designation that you see is a federal guideline for trailers that are over 80 inches wide, and extra lighting is required for these trailers. You should check federal and state lighting guidelines if you are not sure that your trailer has the correct lighting instal
view full answer...
