Fulton Fold-Away Coupler Hinge Kit for 3" x 3" Trailer Tongue - Weld On - Up to 5,000 lbs

Fulton Trailer Coupler - FHDPW330300

Use with actuators or standard couplers to create a foldaway tongue up to 48" long so that your trailer can be stored in even the smallest garage. Weld-on mounting creates a clean look, and the unique offset design guarantees superior performance.

Features:

• Hinge kit lets you create up to a 48" foldaway tongue for your trailer
  • Designed to be used with actuators or standard couplers
• Weld-on installation
• Sturdy steel construction
• Raw finish
• Pivot bolt and pivot pin and clip included
• Made in USA

Specs:

• Application: 3" x 3" trailer tongue
• Capacity: up to 5,000 lbs (see table)
• 5-Year limited warranty

Use the table below to determine your maximum pivot length based on your trailer capacity. Pivot length is the measurement from the center line of the coupler ball to the farthest pivot hole.

HDPW330300 Fulton High Performance Weld-On, Fold-Away Hinge Kit for 3" x 3" Trailer Tongue

Customers Who Purchased This Trailer Coupler Also Bought...

Ask the Experts about this Fulton Trailer Coupler
Do you have a question about this Trailer Coupler?

• Lanuage for fitting Fold-Away Coupler Hinge Kit FHDPW330300
  
• Couplers are the foremost part of the trailer that attaches to the hitch ball. Actuators are trailer couplers that are normally on boats and have a surge break system built in. Standard couplers are couplers without brakes. The Fulton Fold-Away Hinge Kit is the weld on version and there is a bolt on version available to create a foldaway tongue for a 3 inch by 3 inch trailer frame. We also carry both versions for the 3 inch by 4 inch trailer frame. When determining the maximum pivot length
  view full answer...


• Length of Fulton Fold-Away Hinge Kit, part # FHDPW330300
  
• I went out to our warehouse and measured this. The hinge is 4 inches deep at the longest angle. At the shortest, it is 3-1/4 inches long.
  view full answer...


• How Do You Weld the Fulton Weld On Hinge Kit for 3x3 Tailer Frame and What Material is it Made Of
  
• The Weld-On Fulton Fold-Away Hinge Kit for 3" x 3" Trailer Tongue, item # FHDPW330300, is constructed of cast steel. All welding must be performed by a certified AWS welder. Making sure casting is straight and fully seated on the tongue tube. Weld complete on all four sides using a 3/16 inch minimum fillet weld.
  view full answer...