Edge Comp for Dodge Cummins 5.9L, 24V

Edge Performance Chip - EP30301

The Edge Comp Module can be quickly installed to provide more horsepower and torque with 5 levels of In-Cab and On-the-Fly adjustment

• Adds up to 120 Horsepower
• Can switch between 5 available power levels:
  • Stock: 0 Horsepower - 0 Foot Pounds of Torque
  • Level 1: 40 Horsepower - 150 Foot Pounds of Torque
  • Level 2: 60 Horsepower - 200 Foot Pounds of Torque
  • Level 3: 80 Horsepower - 250 Foot Pounds of Torque
  • Level 4: 100 Horsepower - 300 Foot Pounds of Torque
  • Level 5: 120 Horsepower - 350 Foot Pounds of Torque
• Each power level includes 5 independent, adjustable sub-levels to control low boost fueling, providing a total of 25 levels of adjustability.
• Includes responsiveness settings to dial in optimum balance between responsiveness and low boost smoke control
• Increases Fuel Economy
• Maximizes efficiency by monitoring the RPM, Timing, Turbo Boost Pressure, and Fueling Parameters
• Uses engine information to control and enhance timing and fueling

The Edge Comp module maximizes engine efficiency by monitoring the RPM, timing, turbo boost pressure and fueling parameters. The module uses this information to determine and control both fueling and timing enhancements for the Bosch fuel injection pump. Timing and fueling enhancements are controlled via CAN-BUS through the Data Link and by connecting directly into the Bosch fuel injection pump.

The Edge Comp features five power levels with power gains from 40-120 horsepower. Each of the five power levels has an independent five-level adjustable responsiveness setting, providing for a total of 25 levels of adjustability! The responsiveness settings enable you to dial-in the optimum balance between responsiveness and low boost smoke control, no matter what additional power modifications have been made to the engine. The Comp module is fully adjustable on the fly and mounts inside the cab.

Sub-levels 1-3 on the Comp will provide de-fueling below stock. The de-fueling mode is entered only when rpm and boost are below a set value and stock fueling is being increased beyond a set rate. These conditions are different for each sub-level 1-3. During operation, when the de-fueling mode is entered, the rate of fueling increase is limited, which reduces smoke. De-fuel mode is exited once stock fueling equals the fueling controlled by the Comp. This way the transition is smooth and cannot be felt while driving. De-fuel mode is entered the easiest in sub-level 1 and has the smallest allowable fuel increase, while sub-level 3 de-fuel mode is not entered as easily and has a larger allowable fuel increase.

Sub-levels 4 and 5 allow adjustment of the additional fueling above stock based on boost level. Sub-level 5 adds the most fuel at low boost; Sub-level 4, which adds less fuel than Sub-level 5, corresponds to jumper setting 2 on the EZ.

The amount of additional fuel added is calculated, the amount actually added after being compared to boost from the total is as shown below:

Sub level 1: 33% is added at 0 psi boost
100% is added at 20 psi boost

Sub level 2: 50% is added at 0 psi boost
100% is added at 15 psi boost

Sub level 3: 67% is added at 0 psi boost
100% is added at 10 psi boost

Fuel may be added at 0 psi boost on all Sub Levels and EZ Jumper settings unless the de-fuel mode is entered as described above.

Power Level 1 on the Comp is the same as the EZ; on Power Levels 2-5 additional power is added via the wire tap onto the injection pump. If the pump wire is not attached with a Comp, Levels 2-5 are still operational, but the power gain is not any higher than Level 1. Under this scenario, however, power will come on much earlier in the throttle

*Legal in California only for racing vehicles which may never be used upon a highway.

Edge Products #30301

Old Part Numbers: ECD2000A, ECD2000B

This Product Fits The Following Vehicles

2001 - 2002 Dodge Ram Pickup 5.9L, Cummins ISB

Ask the Experts about this Edge Performance Chip
Do you have a question about this Performance Chip?

• Can The Edge COMP # EP30301 Be Used with the Edge A2 Monitor on a 2002 Dodge Ram 3500 Diesel?
  
• If your are speaking of the A2 monitor that has been discontinued by Edge, it will not work with Edge Comp models of performance modules. However, the A2 monitor will work with the Juice models. For your 5.9 Liter Cummins, the Edge Juice with Attitute Monitor, item # EJD3500BWAM, will work.
  view full answer...


• On The Edge Comp, # EP30301, Stages 2-5 Stopped Adjusting On A 2001 Dodge Ram 2500
  
• On the Edge Comp for Dodge Cummins 5.9L, 24V, # EP30301, the Power Levels 2-5 additional power is added via the wire tap onto the injection pump. If the pump wire is not attached on the Edge Comp, Levels 2-5 are still operational, but the power gain is not any higher than Level 1. Under this scenario, however, power will come on much earlier in the throttle. You need to check the pump wire connection to make sure it is attached. I am sending a link to the instructions for the Edge Comp, # EP
  view full answer...


• Do I Need to Make Fuel Pump Modications before I Install a Edge Comp for Dodge Cummins, # EP30301
  
• Your diesel mechanic is giving you sound advice. I researched your truck and found that the fuel pump systems in your generation of Dodge Rams are notorious for going out, and with the addition of a programmer on your vehicle, you will accelerate the chances of the pump going out and causing even more damage. Depending on the power goals you have for your truck, you may not need the 95 GPH FASS system, as there is a economical 89 GPH FASS that might work for your truck. As a rule of thumb,
  view full answer...


• Do I Also Need EGT Gauge When Using Edge Comp Chip on 1999 Dodge Ram 3500 Cummins Diesel
  
• I contacted our representative at Edge and he informed me that it would be a good idea to have an EGT Gauge installed when using higher settings on the Edge Comp. He also recommended installing a fuel pressure gauge and lifter or aftermarket fuel pump. You will want to make sure the motor is getting enough fuel when using the higher setting. The item you referenced, Edge Comp, part # EP30301 is for the 2001-2002 Dodge Ram 5.9L Cummins. For your 1999 Dodge Ram 5.9L Cummins, you should have
  view full answer...