See What Fits Your Vehicle
customer service | view cart  View Cart

Hitch Accessories > Anti-Rattle > Universal > Fits 1-1/4 Inch Hitch, Fits 2 Inch Hitch, Fits 1-1/4 and 2 Inch Hitch > Non-Locking > Wedge Style > Steel > Boone Outdoor

No-Rattle Trailer Hitch Wedge for 1-1/4" and 2" Trailer Hitches by Boone Outdoor Hardware

Boone Outdoor Hitch Accessories

Rating: ratingratingratingratingrating
27 reviews


Code:   93347

Retail:$8.95

Price:$7.99

Shipping Weight: 1 pounds

Shipping Special
Quantity: 





Boone Outdoor Hitch Accessories - 93347

No-Rattle Trailer Hitch Wedge by Boone Outdoor Hardware

Don't be fooled by its size. This little wonder has a big job. The Hitch Wedge performs double duty by holding your hitch gear tightly and providing extra security for the hitch pin. Hitch racks will stand stone cold solid with the Hitch Wedge. Install it and forget about it.

  • Serves as hitch gear stabilizer
  • Wedges itself between the receiver and hitch gear to take up play and eliminate irritating rattle
  • Holds hitch pin tight
  • Is easier to use and less expensive than other stabilizers
  • Doubles as anti-theft device
  • Carbon steel construction
  • For 1-1/4" x 1-1/4" and 2" x 2" trailer hitches

Note: Will not work with trailer hitch locks that sit flush against the outside of the hitch receiver. Will not work on Ford Edge vehicles with a factory installed 1-1/4" trailer hitch.

93347 2" and 1-1/4" No-Rattle Hitch Wedge by Boone Outdoor Hardware






Customers compare 93347 to these similar products





Customers Who Purchased This Hitch Accessories Also Bought...






Customer Reviews

No-Rattle Trailer Hitch Wedge for 1-1/4 - 93347

Average Customer Rating:  ratingratingratingratingrating3.3 out of 5 stars   (27 Customer Reviews)




- 93347

ratingratingratingratingrating by: Darrell B.07/20/2010

Is this review helpful?


Work very well for highway use I used these on an extension hitch of 41" for my Lance camper overhang. Used 1 on each receiver for lateral movement and chain turnbuckles for vertical movement. This combination along with a 1500 lb. trailer pulls great on the highway. I would not expect the same results if I tore off down a logging road like a bat out of hell. If used with fairly constant hitch weight on fairly even surface and one not two devices (not enough room) to press hitch against the opposite wall of receiver it will surely keep the tail from wagging the dog while going down the highway. 3254

comment on this review


- 93347

ratingratingratingratingrating by: Richard10/06/2011

Is this review helpful?


It does help side to side rattle. Eye bolt could be heavier25160

comment on this review


- 93347

ratingratingratingratingrating by: Norm W08/09/2011

Is this review helpful?


Looked al over for something like this. I never found anything tahat east to install that worked like it said it should. Thanks etrailer21477

comment on this review


- 93347

ratingratingratingratingrating by: James03/22/2013

Is this review helpful?


Product would not work with my 11/4 hitch and receiver. Should have listened to other reviews of this item. Could not get it to wedge between receiver and hitch. Inexpensive so not much lost.71830

comment on this review


- 93347

ratingratingratingratingrating by: Leon03/18/2013

Is this review helpful?


I'm terribly disappointed in this product. I hoped it would work. However, it has good intentions on paper, but in function, needs a lot of refinement. The more I tightened it, the more the wedge cocked to an angle. It doesn't pull tension straight back. 71360

comment on this review


- 93347

ratingratingratingratingrating by: David02/28/2013

Is this review helpful?


Just put it on to give it a try. It was real easy to put on. I wish I had ordered this piece prior to my recent trip. It appears to stop the swaying. We'll see in about 3 weeks when we drive out to San Diego with bikes in tow on the rack how it functions. I do feel a noticeable difference already by the snugness when I tightened it on the connector. I feel good about the potential result. Stay tuned. 68240

comment on this review


- 93347

ratingratingratingratingrating by: Harvey H.01/16/2013

Is this review helpful?


Simple design that works well and is not too cumbersome to use... doesn't make it rock solid but makes the rattling go away... I use it for a cargo carrier, receiver mounted winch, and a road feeder... Don't over tighten, the black hardend steel wedge can break...but that was my fault, was trying to make it rock soild, which is not its design. Also slows down theft...63264

comment on this review


- 93347

ratingratingratingratingrating by: Al W.10/19/2012

Is this review helpful?


Disappointing. Doesn't really do much. Light duty, I guess you get waht you pay for!57622

comment on this review


- 93347

ratingratingratingratingrating by: Peter08/31/2012

Is this review helpful?


Great product and fast delivery. 53708

comment on this review


- 93347

ratingratingratingratingrating by: Jim B.08/20/2012

Is this review helpful?


Excellent customer service, fast delivery, top quality product and Excellent fit. So what's not to like? I'd highly recommend.52396

comment on this review


- 93347

ratingratingratingratingrating by: Dave D07/27/2012

Is this review helpful?


A must to have for such a low price, firms up the cargo rack nicely. Very easy to use/install.49576

comment on this review


- 93347

ratingratingratingratingrating by: snorth07/05/2012

Is this review helpful?


Not bad for the price point. 46772

comment on this review


- 93347

ratingratingratingratingrating by: Don P.04/08/2012

Is this review helpful?


Instructions are on the skimpy side, but any slightly mechanically inclined (i.e., can change your own oil) should figure it out. Bracket it is easy to bend and care must be taken not to overtorque the nut.36543

comment on this review


- 93347

ratingratingratingratingrating by: Tim A08/26/2011

Is this review helpful?


eTrailers customer service is A+. Haven't tried the wedge yet but appears to be a useful tool.22889

comment on this review


- 93347

ratingratingratingratingrating by: Scott, A.08/15/2011

Is this review helpful?


Installed per the picture, and video on site. tighten it down, but still rattled. Did not work with my Curt hitch, also ordered from etrailer. The cluncking is a bit unnerveing with these "wonderful" Chicagoland roads!!! Back to looking for the one that fits over the shank of the drawn accessory, for the 1 1/4" shank.21952

comment on this review


- 93347

ratingratingratingratingrating by: RICK LAYMAN08/02/2011

Is this review helpful?


WORKS GREAT, FAST SHIPPING 20926

comment on this review


- 93347

ratingratingratingratingrating by: Michael B.07/31/2011

Is this review helpful?


I couldn't use the Hitch Wedge because it wouldn't work with factory installed Ford Edge hitches.20630

comment on this review


- 93347

ratingratingratingratingrating by: Michael B.07/31/2011

Is this review helpful?


I purchased the - 6500 20x48 cargo carrier for a 1 1/4 inch hitch. It was just what I was looking for. It is easy to use and is very quiet. I would recommend my carrier with five stars.20629

comment on this review


- 93347

ratingratingratingratingrating by: Gary07/07/2011

Is this review helpful?


This wedge was not effective in fitting between trailer hitch opening and my 1.25 inch bar. The wedge tip was too thick thus not fitting tight. In addition, tightening of the bolt to try to get it to insert more effectively resulted in the screw threads to wear and slip. I would return but not worth shipping costs. 18842

comment on this review


- 93347

ratingratingratingratingrating by: John D.07/06/2011

Is this review helpful?


This did not work at all from the start. Could not even begin to see if it would provide rattle relief.18578

comment on this review


- 93347

ratingratingratingratingrating by: Jeremiah D.06/24/2011

Is this review helpful?


This hitch accessory worked on my 1 1/4" hitch, it reduced greatly but did not stop rattle. I added a lock washer to reduce chance of loosening. It was easy to install but very difficult to remove, having wedged into the hitch (as designed). Service from etrailer was excellent! Item arrived sooner than promised.17853

comment on this review


- 93347

ratingratingratingratingrating by: J Cole06/22/2011

Is this review helpful?


Thank goodness for quiet. This is a great product, and I got great service. Shipping was great and quick.17693

comment on this review


- 93347

ratingratingratingratingrating by: Mike S05/17/2011

Is this review helpful?


The product is what we hoped for. 14525

comment on this review


- 93347

ratingratingratingratingrating by: Derek C05/10/2011

Is this review helpful?


A+.... It works well. I love it. 13226

comment on this review


- 93347

ratingratingratingratingrating by: Adam S.04/08/2010

Is this review helpful?


Cheap because they don't work I bought 2 of these for my hitch to keep my hitch ball and bike rack from rattling while going down rough bumpy roads and they didn't help at all. They are hard to adjust and don't fit right, they only are designed to stop side to side rattle and not up and down rattle that the get with a single axle trailer or a bouncing bike rack. I would not recommend these and should of spend more for a better designed product. 2921

comment on this review


- 93347

ratingratingratingratingrating by: Journeydog05/08/2009

Is this review helpful?


Broke while installing Great concept, but not very strong material. 100lb. wife tried to tighten and bracket broke in half.1826

comment on this review


- 93347

ratingratingratingratingrating by: Doc L04/22/2011

Is this review helpful?


This hitch went on my 03 Ranger even easier than anticipated. Even though the instructions said (and I was prepared to) to drill a hole in the frame using the hole in the hitch bracket as a guide, my Ranger had the hole already in the frame so it was just a matter of bolting it up to the frame after removing the old bolts and J-nuts. On the Ranger there was lots of room to get my hands up to put the bolts in place and tighten the nuts. It took about an hour but that was only because I did not have another set of hands while laying on my back under the truck to help put the hitch in place. It went on much easier than the one I put on my 07 Nissan Murano. On the Murano I had to bend the bracket on the hitch several times to make the holes line up. I was told by customer service that this was typical on 80% of the hitches. 12225

comment on this review


Ask the Experts about this Boone Outdoor Hitch Accessories
Expert Answers about No-Rattle Trailer Hitch Wedge for 1-1/4" and 2" Trailer Hitches by Boone Outdoor Hardware - 93347                                             Do you have a question about this Hitch Accessories?


  • Anti-Rattle Device for a Toyota Prius Towing a Bike Rack with a 1-1/4 Hitch
  • We have two anti-rattle alternatives that are compatible with a 1-1/4 inch receiver. The CURT Trailer Hitch Anti-Rattle Kit, part # F-315 works very well. The block with nut is placed inside the ball mount (or hitch accessory) and drawn to the side of the hitch tube when the pin is tightened. This pushes the ball mount or hitch accessory up against the side of the hitch tube, dramatically reducing movement and vibration. Also available is the No-Rattle Hitch Wedge, part # 9337. This wedge at
    view full answer...

  • Does the No-Rattle Trailer Hitch Wedge Fit Both 1-1/4 and 2 inch Hitches
  • Item number 93347, No-Rattle Trailer Hitch Wedge, part # 93347, fits both the 2 inch and the 1-1/4 inch hitch sizes. We do not carry the 92212 part because the 93347 part will work for both hitch sizes and is essentially the same product. The wedge that tightens the shank into the receiver is 1-1/8 inch wide and will adjust down to 2 inches from the farthest forward side (closest side to vehicle) of the hitch pin.
    view full answer...

  • Can the No-Rattle Trailer Hitch Wedge # 93347 be Used with a Receiver Hitch Lock
  • I went out to the warehouse and tried the DeadBolt 1-1/4 inch Hitch Lock, item # 7682, along with the No-Rattle Trailer Hitch Wedge, item # 93347, and a Class II trailer hitch and drawbar. This lock does not leave enough room between the receiver and the lock housing to install the No-Rattle Trailer Hitch Wedge. I also tried the Draw-Tite 1-1/4 inch Hitch Lock, item # 5200 and it works nicely with the No-Rattle Trailer Hitch Wedge.
    view full answer...

  • Installation of Boone Anti-Rattle Hitch Wedge # 93347
  • I went out to the warehouse and pulled one of the Boone Outdoor Hardware hitch stabilizers off of the shelf. The paper card included with the stabilizer did not provide any instructions, just a photo of the installed stabilizer. If you look at the photo I have edited for you, you should get a good idea of how the wedge fits. I have also filmed a short video for you showing how the Boone Stabilizer is used.
    view full answer...


Info for this part was:


Written by:
Ty

Edited by:
Fran

Expert Research
Bob

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.





Subscribe to email newsletter

Email  

privacy - we don't send unsolicited email




etrailer.com reviews etrailer.com reviews

All images, layout and content copyright etrailer.com