Hidden Hitch Class II Trailer Hitch Receiver with Drawbar

Hidden Hitch Trailer Hitch - 90145

Hidden Hitch Class II Trailer Hitch

• Trailer hitch is dipped in a black rust resistant coating
• Custom designed for each vehicle type and model year for simple installation and better fit
• Low profile design to compliment the rear contours and aerodynamic styling of today's vehicles
• Trailer hitch includes mounting hardware and easy to read installation instructions (see Typical Installation Instructions in the "detailed info" link)
• Simple bolt-on installation, no welding required
• 1-1/4" square receiver opening
• Removable drawbars and ballmounts eliminate banged or bruised shins and enhance the appearance when not in use
• Drawbar, pin and clip are included
• All Hidden Hitch trailer hitches and exceed V5, VS, CSA, and SAE J684-98 standards are inspected for quality workmanship
• All Hidden Hitch trailer hitches have a limited lifetime warranty

This Product Fits The Following Vehicles

Customers Who Purchased This Trailer Hitch Also Bought...

Hitch Ball with 2" Diameter and Short Shank, 3,500 lbs GTW - Chrome $6.95

Hitch Ball with 1-7/8" Diameter and Short Shank, 2000 lbs GTW - Chrome $6.95

Rubber Tube Cover 1-1/4" $3.99

American Flag 1-1/4" Trailer Hitch Receiver Cover $14.95

Hidden Hitch Class II Trailer Hitch Receiver with Drawbar - 90145

Nice looking hitch - May 18, 2007

by: Don H. from Cleveland, OH

Rating:

4.6 out of 5 stars

2007 Saturn Vue. I could use longer bolts for the 2 center spots where the bolts are fed through the frame. The feed wires should be 12" longer and need two because the first one gets damaged doing the first bolt. Too bad Saturn doesn't have threaded holes in the frame like they do for the ends. Good paint job by Hidden Hitch and would buy it again.

Hidden Hitch Class II Trailer Hitch Receiver with Drawbar - 90145

Can't install per directions - Sep 11, 2007

by: Dan L. from Long Island, NY

Rating:

3.0 out of 5 stars

A nice hitch that fit into place fine, but it is impossible to install per the provided directions and the pull wire provided. The pull wire was too short and too flimsy to even feed the heavy bolt - resulting in the bolt getting lost inside the bumper. This was frustrating to say the least. I was able to complete the job using an electrician's fish tape. The electrical hookup was easy, but the hitch was a real pain!

Ask the Experts about this Hidden Hitch Trailer Hitch
Do you have a question about this Trailer Hitch?

• Do the Hitches for the 2010 Chevrolet Equinox Come with Installation Hardwrare
• Yes, all of the trailer hitches we sell come complete with the mounting hardware needed for installation.   view full answer...