Demco Trailer Coupler - 8605001
Demco Hydraulic Brake Actuators are specifically designed to perform even in the harshest braking environments. The master cylinder cap has an automotive-style diaphragm for a completely enclosed brake system preventing brake fluid contamination. Master cylinder pushrod is covered by a rubber boot for additional dirt and moisture protection.
- Ball Size: 2"
- 3" Channel Mounting
- 6,000 lbs. Capacity
- Bolt holes measures 3" apart (on center)
Model # DA66B
Customers Who Purchased This Trailer Coupler Also Bought...
Ask the Experts about this Demco Trailer Coupler
Do you have a question about this Trailer Coupler?
- Advice for Reomving Deteriorated Master Brake Clinder Cap on Hydraulic Brake Coupler
- The challenge here is to keep the remains of the cap in one piece long enough to remove it. I would suggest mixing up some 2 part epoxy and coating the cap with it. If you are careful to avoid getting the epoxy down into the threaded portion of the cap, once it cures you should be able to get the cap off. If you should get pieces of the cap into the master cylinder, most hydraulic couplers are set up so that the master cylinder is removable, you could remove it if needed and clean it out.
view full answer...
- Installing Hydraulic Trailer Brakes on a Kristi Utility Trailer
- There are two ways to go. Drum brakes and Disc brakes. To determine which assemblies will fit on your spindles we will need to know the inner and outer bearing and seal part numbers. We will also need the Brake Mounting Flange bolt pattern on the spindles and the bolt pattern and size of the wheels that are on your trailer. For the hydraulic actuator we will need the size of the trailer tongue where the actuator will mount.
If you will get back to me with your choices and the needed informati
view full answer...
