EGR In-Channel Slimline Window Visors (4 Piece)

Video Transcript for EGR Tapeless Window Visors Review

Today we are going to show you how to install EGR tapeless window visors, part # 571351. This will fit the Chevrolet Trailblazer 02-06 and the GMC Envoy XL 02-06. This kit is a four piece system that covers all four windows, it is pretty simple to install. We are going to start with the first half front windows. All they do is pop in and slide into the track. To slide it in the track, there will be a lot of twisting and bending, but it will bend and flex to accommodate that. Once you get the window visors installed, a good thing is to run your windows up and down a few times. The window will drag on the plastic a little bit as you can see. The plastic does get pushed up by the window. What you want to do is actually take some time and run them up and down a few times and let them sit in the sunlight preferably or at least in a warm environment. That way it will conform to the window and the seal around the window.

Sometimes it may not reach all the way up. If that is the case, leave it like it is and let it sit for a while. Then run it up and down a few more times to get it to roll up completely. After that, you want to actually let it sit for a day or two in the sunlight. That would be perfect thing for it with the windows up.Now we are going to work on the rear window visors. This will simply fit in the track, slide up in here and go in like that. However, if you notice on this particular model, there is tape on here. It does say tapeless, the reason for that is there is nothing for it once it is propped in to work against. So it has to have the tape that will go against the seal on the inside, to have something to grip it to. It will have the flexibility of being pinched in on the sides too, like so. That is just extra assurance of it staying in place.

First thing we need to do before installing is to go ahead and clean out the track. It is good to use some paper towels and some rubbing alcohol to clean out the seal in here so it has a good clean surface to adhere to. I will go ahead and start doing that. When we install them, slide them in the track down below first, and keep pushing against that way so it does not touch the outside edge. Keep doing that as you push it into position. Then when you get it up high enough, the way you want it, then pull it out and let the adhesive touch the outside edge. Once you have that done, go ahead and roll your window up and down a few times and leave it up for at least a day. That is all that is needed, a few simple steps to install the window visors. Some nice features about the visors are it is integrated into the window tracks so it looks like its part of the vehicle. That also makes it easy to install. Being on the in track also, even though this model does have adhesive being in the track, makes it stick better because it has the strength of being in the track and the adhesive too. This is overall a nice edition to your vehicle.