Trailer Hub & Drum - 5,200 and 6,000 lbs Axles - 6 on 5-1/2

Dexter Trailer Hubs and Drums - 42656

• Used on Dexter 5,200 lbs and 6,000 lbs axles, or on spindles requiring a 2-1/8" or 2-1/4" I.D. Grease Seal
• Capacity of 3,000 lbs per each
• Drum Size: 12" x 2"
• Bolt Pattern: 6 on 5-1/2 (for information see below)
• Bearings, lug nuts, cap, and seal not included
  • 25580 Inner / 15123 Outer Bearings
  • Use either BK3-100 or BK3-110 Bearing Kit (according to your seal dimensions)

Typical Photos

How to Measure Bolt Pattern

The first number in the bolt pattern is the number of bolt holes. The second number is the diameter of the circle the holes sit on. To determine the diameter on wheels with an even number of bolt holes, measure center-to-center on bolt holes directly across from each other on the circle (Example: 8 on 6-1/2 would mean 8 bolt holes with 6-1/2" center-to-center diameter). When the number of bolt holes is odd, measure from the center of any bolt hole to the point halfway between the two bolt holes directly across from it on the circle (Example: 5 on 4-1/2 would mean 5 bolt holes with 4-1/2" measured to a point halfway between the opposite bolts).

Customers Who Purchased This Trailer Hubs and Drums Also Bought...

Replacement parts available for this product

Ask the Experts about this Dexter Trailer Hubs and Drums
Do you have a question about this Trailer Hubs and Drums?

• Can a Dexter Hub and Drum Assembly Replace an AL-KO Trailer Hub and Drum Assembly
  
• Yes, a Dexter Hub and Drum like # 42656 will be interchangeable with an AL-KO hub and drum of the same size. When replacing the hubs, you need to make sure you get the proper hub for the spindle on the axle. Each trailer manufacturer uses a range of spindle sizes depending on the application. To determine the exact replacement, you will need to pull one of the existing hub/drums, locate the bearings, and get the bearing numbers that are stamped into both the inner and outer bearings. With thi
  view full answer...


• Will There Be Sufficient Clearance To Mount Kenda Tire and Wheel # AM3S870
  
• I walked out to our warehouse and pulled the Kenda Tire and Wheel, part # AM3S870. I measured from the back of the mounting flange on the wheel to the edge of the tire. I shot a video showing these measurements for you to checkout. I have also linked an FAQ on trailer tires.
  view full answer...


• Hub and Wheel Recommendations for Converting to Oil Bath Hubs
  
• As far as caps are concerned the main difference between an oil and grease caps is how they have to attach to the hub. Grease hubs will press in, while oil seals need to be screwed into a threaded hub. You will need to upgrade to oil bath hubs. We have oil bath hubs that would fit your spindle, except they all have a 8 on 6-1/2 inch bolt pattern. One of them is the Trailer Hub and Drum Assembly # 8-219-9UC3. This hub would work on your trailer, but you would need rims that have the same bo
  view full answer...