Tekonsha Voyager Electric Trailer Brake Controller with General Motors Adapter (2003-2006)
Inertia or pendulum style controllers are enabled by the brake pedal switch and activated by a pendulum circuit that senses the vehicle's stopping motion and applies a proportional voltage to the trailer's brakes. The brake controller must be mounted and calibrated level.
- Features:
- Designed for 2, 4, 6 and 8 brake trailers
- Green LED monitors a secure connection with trailer and changes to red to indicate an increase of power to the trailer brakes
- Inertia Activated (Proportional Braking Power)
- Ergonomically designed control lever for easy, accurate gain and level settings
- Includes mounting bracket
- Vehicle specific wiring adapter is included to ease installation
- 5-year Limited Warranty
- Specs:
- Dimensions: 3" Wide x 5" Long x 1-1/2" High
- Made for up to 4-axle trailer brake systems (2 to 8 Brakes)
- Must be mounted between -20 degrees and 70 degrees vertically
- Installation:
The vehicle specific adapter has one end with a plug that connects to a port in the black box located under the dash. The other end of the adapter has four bare wires that attach to the four corresponding wires on the brake controller.
Note: If your vehicle has a factory installed hitch and 7-way connector, then all of the wires for the brake controller have already been run. If not, additional parts will be required to complete the installation of the brake controller.
Tekonsha Voyager Brake Controller 39510 with Adapter 20264