Class II Drawbar - 4-3/4" Drop

Draw-Tite Ball Mounts - 36078

Class II Hitch Drawbar /Bball mount

• Fits 1-1/4" x 1-1/4" Class II receiver-style hitches
• Uses ball with 3/4" shank diameter
• Measures 7-1/2" long from center of pin hole to center of ball hole
• Provides 4-3/4" drop from the top of your hitch's receiver tube
• Rated for up to 3,500 lbs gross trailer weight and up to 300 lbs tongue weight
• Includes pin and clip
• Has black finish

Customers Who Purchased This Ball Mounts Also Bought...

Ask the Experts about this Draw-Tite Ball Mounts
Do you have a question about this Ball Mounts?

• Using a 36078 Class II Drop Drawbar as a Rise Instead of a Drop
  
• The drawbar you mentioned is not intended to be used in the rise position and would only create a 3-1/2 inch rise. We do carry a 5 inch and a 3-1/8 inch rise drawbar (see links below) that will fit the Class II hitch. These drawbars all have a tongue weight capacity of 300 lbs and a towing capacity of 3500 lbs. Keep in mind that if you need a significantly higher or lower drawbar to tow (you are not able to use the manufacturer's recommended drawbar for the hitch), you will void the manufactur
  view full answer...


• Parts to use a Class 3 or Higher hitch with a Class 1 or 2 Tow Load
  
• If you already have 1-1/4 inch ball mount that are the proper size for your trailer, you can use a reducer sleeve like part # HT02. If you want to continue using the ball you have, you would need a ball mount with a 3/4 inch ball shank diameter hole, which will be Class 1 and 2 ball mounts and would again need reducer sleeve part # HT02. If you have to buy a new ball mount since you switched to a 2 inch hitch and may need more drop, I would go ahead and buy a 2 inch ball mount and a 1-7/8
  view full answer...