Plug-N-Tow (TM) Wiring Harness

Hopkins Custom Fit Vehicle Wiring - 33515

Plug-N-Tow (TM) Wiring Connectors provide a no-hassle, quick and easy way to wire your vehicle.

• Each vehicle specific connector is pre-wired and uses original OEM connectors for water tight protection, a guaranteed fit, and a great look
• No cutting or taping
• 16 gauge wire
• 4-Pole connector includes dust cap
• Easy to follow instructions with pictures are included
• Converter load is a maximum of 2.1 amps per stop/turn signal (one turn signal on each side)

Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection point is located behind the rear bumper on the passenger side frame rail.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.

Hopkins # 43515

This Product Fits The Following Vehicles

1998 - 1999 Nissan Frontier

2000 - 2004 Nissan Frontier 2 Door only

2000 - 2004 Nissan Frontier 4 Door only

Customers Who Purchased This Custom Fit Vehicle Wiring Also Bought...

Ask the Experts about this Hopkins Custom Fit Vehicle Wiring
Do you have a question about this Custom Fit Vehicle Wiring?

• Where is the Connection for the 33515 Trailer Wiring Harness on a 2004 Nissan Frontier
  
• You will find a connection point for the Plug-N-Tow Wiring Harness, item # 33515, behind the rear bumper on the passenger side frame rail. This wiring harness has a converter installed and plugs in line with the original factory connectors.
  view full answer...


• Brake and Turn Signals Not Functioning when Taillights are Activated on a 2003 Nissan Frontier
  
• The situation you are describing sounds like a classic ground issue. When the tail lights are on the amperage draw is the greatest and if the grounding point chosen is not sufficient the lighting will not function properly. Since you have tried two harnesses from different manufacturers and have tried different grounding locations, I would try running the ground wire from the Tow Ready wiring harness, # 118362, to the negative post of the vehicle battery. If this solves the issue, you can try
  view full answer...


• Trailer Lights Not Working After Installing the Hopkins Trailer Wiring on a 2003 Nissan Frontier
  
• It sounds like the converter on your Hopkins wiring harness, # 33515, is not working correctly. The first step I would take is to use a circuit tester, like part # 3808, to check the trailer plug on the wiring harness for proper function without a trailer connected. If there is power there when the brakes, turn signals and taillights are activated, then you know that the ground for the wiring is not connected properly and you will need to check the vehicle connector and trailer wiring for suffic
  view full answer...