Valley Odyssey II Electric Trailer Brake Controller with Hardwire Quick Disconnect Adapter
The new double-axis accelerometer technology continually checks and then adjusts for varying road terrain. The brake controller also senses the vehicle's rate of deceleration and applies a proportionate amount of braking power to the trailer as fast as is needed, providing only the smoothest of stops, just like the original Valley Odyssey. Upgrades include 4 memory preset locations for your different trailers, pressure sensitive manual trailer brake activation and enhanced display graphics! A hardwire quick disconnect adapter is included for vehicles that are not equipped with a pre-wired brake controller plug under the dashboard. This adapter allows you the benefit of the quick disconnect feature of the brake controller with a few simple wiring connections.
- Features:
- Trailer brake controller with hardwire plug-in adapter
- Aside from smoother stops, proportional braking means less wear on both the trailer and vehicle brakes
- Works proportionally, even when traveling in reverse
- Auto-leveling for an even easier installation
- Exclusive 4 Load Range ("Boost") settings for even greater adjustment
- Press-down pressure sensitive manual override will still activate brake lamps
- 4 User Memory Presets - retains the Power Output and Load Level setting combinations for specific trailers, loads or driver specifications
- Easy to read digital display
- Diagnostics system continually checks for shorts and trailer connection
- Power saving mode increases vehicle battery life
- Includes mounting bracket
- Additional mounting brackets are sold separately making it easier to use the same controller in more than one vehicle
- Quick Disconnect feature allows removal and storage of the controller when not in use
- Hardwire quick disconnect adapter is included to make installation simple
- Controller will work on most trailers with electronically activated hydraulic brake systems
- Valley Odyssey II is polarity protected - if the positive and negative leads are reversed the unit will isolate itself from power input
- Limited lifetime warranty
- Specs:
- Dimensions: 3-5/8" Wide x 4-3/4" Long x 1-1/2" High
- Made for up to 4-axle trailer brake systems (2 to 8 Brakes)
- 360 degree vertical plane operating range
- Can be mounted pointing straight down or straight up
- 20 degree horizontal mounting range
- Boost levels increase power up 0%, 16%, 25% and 28%
- Power saving sleep mode draws .003 milliamps
- Made in the U.S.A.
- Installation:
The hardwire quick disconnect adapter has one end that plugs into the back of the brake controller while the other end has bare wires to connect with the vehicle wires used for the installation of a brake controller.
Note: If your vehicle has a factory installed hitch and 7-way connector, then all of the wires for the brake controller have already been run. If not, additional parts will be required to complete the installation of the brake controller.
Valley Odyssey II Brake Controller 32810 with Adapter V30520
Instructions
