Tow Ready Wiring Adapter for Electric Brake Controllers - GMC

Draw-Tite Accessories and Parts - 20269

Ease installation of your electric brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in harness beneath your vehicle's dash.

Features:

• Pigtail wiring adapter eases installation of your electric brake controller
• Connector end plugs into the built-in port beneath the dash of your vehicle
• Wire end connects to the wires on your brake controller with the included butt connectors
• Limited 1-year warranty

Installation of Tow Ready Brake Controller Adapter

This adapter plugs into the 6-pin connector on your vehicle's built-in brake control wiring harness. The harness is located underneath the dash, to the left of the steering column, taped to another harness near the emergency brake pedal.

To install your electric brake controller you need to connect the four wires - ground, power, brake switch and brake power - of the controller to your vehicle. Certain manufacturers offer pre-wired options, typically known as tow packages, wherein these wires are run for you from the dash to the trailer connector on the back of your vehicle. Often, a brake controller wiring harness is included with your tow package. This harness plugs into a port beneath your dash and connects to the four wires of the brake controller. If you do not have a harness, or you need a new one, the Tow Ready wiring adapter will serve the same purpose.

20269 Tow Ready Brake Control Wiring Adapter

This Product Fits The Following Vehicles

2007 - 2012 GMC Acadia with factory 7-Way

2008 - 2012 Buick Enclave with factory 7-Way

2007 - 2010 Saturn Outlook with factory 7-Way

2009 - 2012 Chevrolet Traverse with factory 7-Way

Ask the Experts about this Draw-Tite Accessories and Parts

• Wiring a Voyager Brake Controller on a 2011 Chevrolet Traverse With a # 20269 Wiring Adapter
  
• Yes, you will match the like colors on your Tekonsha Voyager, item # 39510, with the wires on the Universal Brake Control Wiring Adapter, item # 20269, for installation on your 2011 Chevrolet Traverse. This harness is for the older Voyager brake controllers with blunt cut wires. We have installation instructions, see link, for you to review. If you have a newer Voyager, item # 39510, with the connector on the back you should use the Tekonsha Wire Replacement, item # 3026-P, to plug into th
  view full answer...


• Brake Controller Wiring Harness Location on a 2011 GMC Acadia
  
• From what I see, if your 2011 GMC Acadia has a factory installed 7-Way trailer connector, then all you will need to do is plug in the plug side of the wiring harness, # 20269, into the matching connector on the vehicle. It is located underneath the dash and to the left of the steering column. It will be taped to another harness close to the emergency brake pedal. The bare wire end gets connected to the brake controller by color. White = ground Black = 12 volt power Blue = output Red = brak
  view full answer...