Ease installation of your electric brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in harness beneath your vehicle's dash.
Features:
This adapter plugs into the 4-pin connector on your vehicle's built-in brake control wiring harness. The harness is located underneath the dash, to the left of the steering column, taped to another harness near the emergency brake pedal.
To install your electric brake controller you need to connect the four wires - ground, power, brake switch and brake power - of the controller to your vehicle. Certain manufacturers offer pre-wired options, typically known as tow packages, wherein these wires are run for you from the dash to the trailer connector on the back of your vehicle. Often, a brake controller wiring harness is included with your tow package. This harness plugs into a port beneath your dash and connects to the four wires of the brake controller. If you do not have a harness, or you need a new one, the Tow Ready wiring adapter will serve the same purpose.
2009 - 2012 Honda Pilot with factory 7-Way
2006 - 2012 Honda Ridgeline with factory 7-Way
Ask the Experts about this Draw-Tite Accessories and Parts
Do you have a question about this Accessories and Parts?