Tow Ready Wiring Adapter for Electric Brake Controllers - Toyota and Lexus

Draw-Tite Accessories and Parts - 20265

Ease installation of your electric brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in harness beneath your vehicle's dash.

Features:

• Pigtail wiring adapter eases installation of your electric brake controller
• Connector end plugs into the built-in port beneath the dash of your vehicle
• Wire end connects to the wires on your brake controller with the included butt connectors
• Limited 1-year warranty

Installation of Tow Ready Brake Controller Adapter

This adapter plugs into the 5-pin connector on your vehicle's built-in brake control wiring harness. The harness is located underneath the dash, to the left of the steering column, taped to another harness near the emergency brake pedal.

To install your electric brake controller you need to connect the four wires - ground, power, brake switch and brake power - of the controller to your vehicle. Certain manufacturers offer pre-wired options, typically known as tow packages, wherein these wires are run for you from the dash to the trailer connector on the back of your vehicle. Often, a brake controller wiring harness is included with your tow package. This harness plugs into a port beneath your dash and connects to the four wires of the brake controller. If you do not have a harness, or you need a new one, the Tow Ready wiring adapter will serve the same purpose.

20265 Tow Ready Brake Control Wiring Adapter

This Product Fits The Following Vehicles

2003 - 2011 Toyota 4Runner with factory 7-Way

2010 - 2011 Lexus GX 460 with factory 7-Way

2004 - 2009 Lexus GX 470 with factory 7-Way

2003 - 2011 Toyota Land Cruiser with factory 7-Way

2003 - 2007 Lexus LX 470 with factory 7-Way

2008 - 2011 Lexus LX 570 with factory 7-Way

2003 - 2011 Toyota Sequoia with factory 7-Way

2005 - 2012 Toyota Tacoma with factory 7-Way

2003 - 2012 Toyota Tundra with factory 7-Way

Customers Who Purchased This Accessories and Parts Also Bought...

Ask the Experts about this Draw-Tite Accessories and Parts
Do you have a question about this Accessories and Parts?

• What Parts are Needed to Install a Brake Controller on a 2003 Toyota Tundra with No 7-Way
  
• All Tundra models may have that connector port underneath the dash, but only models that were built at the factory with 7-Ways will have those ports wired and active. Since you do not have a 7-Way, it would be safe to assume that even if the port is there, it will not be functional. First you will need to add a 7-Way. We offer a complete kit that will allow you to install a 7-Way and connect a brake controller. The 7-Way kit is part # ETBC7, and it includes everything you will need to be rea
  view full answer...


• How to Install Adapter 4 Pole to 5 Pole Trailer Wiring Adapter # 20036 on a 2007 Toyota FJ Cruiser
  
• What you will need to go from the 4-Way flat on your Toyota FJ Cruiser to the 5-Way flat on the boat trailer is a 4-Way to 5- Way adapter. You can either use # 20036, or # 47515 (shorter). The 5-Way end of the adapter would plug into the 5-Way on the boat trailer. The other end would plug into the 4-Way on the vehicle. The extra blue wire would need to be connected to the reverse light circuit behind one of the tail lights. This circuit is used by the trailer side to engage the electric reverse
  view full answer...