Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the T-One Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: There are two connection points. One underneath the dash in the front of the vehicle. The other is under the floor panel in the back on the driver's side. The 4-pole trailer connector will be stowed in the rear cargo area when not in use.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: 1 per side (2.1 amps)
- Max. tail lights: (5.6 amps)
Read vehicle's owners manual and instruction sheet for additional information.
This is a custom fit application for the following vehicles.
Use the
HitchHunter(R) to find what fits.
2008 - 2008 Toyota Highlander
2008 - 2008 Toyota Highlander Hybrid
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Inexpensive & works great!
TS from Edmond, OK
This is very inexpensive, installs easily following the instructions and it works! My only desire would be for the trailer hook-up harness to be a little bit longer...maybe 3"-6".
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
Flawless installation works th
Greg B from Califon, NJ
Nice wiring package but a bit longer would be nice the fit on the hitch is a bit tight. When routing the wiring it might be better to go out the back of the compartment instead of the bottom. Instructions on how to route it would be nice but overall a good unit.
See Larger
Instructions
