Wiring Harness Installation - 2010 Kia Soul - Video
Wiring Harness Installation - 2007 Kia Rondo - Video
Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the T-One Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection points are located behind the vehicle taillights which are accessed from the outside of the vehicle. The 4-pole trailer connector will be stowed under the vehicle close to the trailer hitch. A mounting bracket is recommended.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: 1 per side (2.1 amps)
- Max. tail lights: (5 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
easy installation
Rich from Nashua NH
Easy installation. The green & red wire to the passenger lights is barely long enough. You can pick up needed extra length by installing the control module 180 degrees off of the etrailer video (green and red wires point down instead of up)