Wiring Harness Installation - 2004 Jeep Wrangler - VideoWiring Harness Installation - 2006 Jeep Wrangler - Video
Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the T-One Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection points are located behind the Jeep's taillights. The plugs are wrapped in foam tape and are behind the black plastic protective covers on each side, under the vehicle and next to the bumper. On some vehicles the plugs are are located behind the protective cover and above the rear bumper bracket. In both cases, the 4-pole trailer connector will be stowed under the vehicle close to the trailer hitch. A mounting bracket is recommended.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: (7.5 amps)
- Max. tail lights: (7.5 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Replaces # 18409
This is a custom fit application for the following vehicles.
Use the
HitchHunter(R) to find what fits.
1998 - 2006 Jeep TJ
1998 - 2006 Jeep Wrangler
2004 - 2006 Jeep Wrangler Unlimited
Instructions
