T-One Vehicle Wiring Harness with 4 Pole Trailer Connector

Tow Ready Custom Fit Vehicle Wiring - 118383

Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese

• Provides a 4-pole flat trailer connector for the vehicle
• Quick and Easy
• No Cutting, Splicing or Taping
• Just Plug in the T-One Connector and You're Ready to Tow
• Solid One Piece Construction
• 16 Gauge Bonded Wire w/ 4-Flat Plug
• "Factory" Appearance
• Simple Do-It-Yourself Instructions on Every Package

Can be used with 5-pole, 6-pole or 7-pole adapters.

Installation: Connection points are located behind the vehicle taillights. 4-way flat trailer connector will be stowed in the jack storage compartment in the cargo area of the vehicle.

Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.

Warning:

Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:

• 7.5 amps per circuit

Read vehicle's owners manual and instruction sheet for additional information.

This Product Fits The Following Vehicles

2001 - 2005 Pontiac Aztek 2 Wheel Drive only

2001 - 2007 Buick Rendezvous 2WD and All Wheel Drive

2001 - 2005 Pontiac Aztek All Models

Customers Who Purchased This Custom Fit Vehicle Wiring Also Bought...

Ask the Experts about this Tow Ready Custom Fit Vehicle Wiring
Do you have a question about this Custom Fit Vehicle Wiring?

• 2004 Buick Rendezvous Trailer Tow Wiring Harness Connector Location
  
• There are detailed instructions and photos in the manufacturer instructions, see link, that lead you to the location for the trailer wiring harness connections on the 2004 Buick Rendezvous. You will be routing the wires to the back of each tail light and plugging the connectors from the T-One Wiring Harness, item # 118383, inline with the factory connectors that plug into the vehicle tail lights.
  view full answer...


• 2001 Pontiac Aztec Gives Parking Light Out Error Message with Trailer Wiring Connected to Trailer
  
• If you are getting an error message that a light is out and no light is actually out, there could be a ground problem or a wiring problem on the trailer. Make sure that you ground the white wire of the harness to a clean bare metal surface. Check the trailer and vehicle side connectors for any corrosion and clean it out. Next, check that the grounds on the trailer are attached to clean and corrosion free metal surfaces. A lot of trailer tail lights ground through the mounting studs. If an
  view full answer...


• Can the T-One Wiring Harness #118383 Be Used on a 2007 Buick Rendezvous With Towing Package
  
• You will still be able to use the T-One Vehicle Wiring Harness, # 118383, on your 2007 Buick Rendezvous even though your vehicle has the tow package installed. This harness connects inline with the vehicle tail lights and gets power for the trailer lighting directly from the the taillights. This harness works exactly the same as the tow package wiring once correctly installed, see instructions. The advantage to using the tow package wiring, # 41405, is that the trailer lighting power is suppl
  view full answer...