Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Rating: 
10 reviews
Code: 118355
Retail:$36.10
Price:$29.95
Shipping Weight: 1 pounds
Shipping Special
Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese
Installation: Connection points are located behind the interior trim panel close to the driver side taillight. The 4-pole trailer connector will be stowed in the rear cargo area when not in use.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
Video of T-One Vehicle Wiring Harness with 4 Pole Trailer Connector
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Today on this 2002 Chevrolet Venture we are going to install part number 118355 from Tow Ready. This T- One wire harness actually connects inside the vehicle on the driver side underneath the interior panel. Okay, it is going to be behind this panel right here. So to get to this panel we have to take off this threshold first. When you take this threshold off, there is a bunch of little connections in here. And this one button here rips very easy so be careful when you take it apart. Okay, we will take this fastener apart. And then we will start peeling back the panel. All right, we pulled the panel back, now we have access to our port right here. On some models, this port is actually down below the A/ C unit sometimes too. So it can be a real bear to find but we got lucky here and it is pretty much right out in the open.
So let us plug the matching ends into the T Connector so it locks into place. Now depending on your van again, this connection might be connected to something else. If it is then you would use both ends. But in this case, it is an open port so we are only using one end of the T connector. Next, we will take our converter box and we are going to hide it back behind the sheet metal right here along the back side kind of behind this pipe right here. Take off the adhesive backing, and then stick it right behind that little sheet metal right there where it will be safe and out of the way. We will just tuck our wiring back safe out of the way also. And we will put our panel back together. All right now we will sneak our ground wire back under the plastic here.
And then we will just bring it up right here and this is on all open space underneath the threshold so we can easily run in the ground screw right here. We can go ahead and put our threshold back into place. Route your wire so it does not get pinched. Reinstall your plastic rivets and you are good to go. And your 4-pole wiring harness will stay in here all the time and when you need to use it you just go ahead and pull it out. Just stay away from the door latch itself and pull it over. The weather strip here, just needs a little bit. And you shut the door hatch on it and pull out as much as you need. That finishes our install part number 118355 from Tow Ready.
1997 - 2004 Oldsmobile Silhouette
1999 - 2005 Pontiac Montana All Models
1997 - 2005 Chevrolet Venture All Models
1997 - 1998 Pontiac Trans Sport Van All Models, including Montana
Customers Who Purchased This Custom Fit Vehicle Wiring Also Bought...
Average Customer Rating: 4.9 out of 5 stars (10 Customer Reviews)
by: BigSkyPilot08/11/2010
Is this review helpful?
Easier than Advertised I was expecting a challenge after researching the installation procedure for this wiring harness for my Montana EXT AWD. Was pleasantly surprised that the factory connector was accessible through the panel by simply removing the air compressor panel. Needed a washer for the ground screw as it would not snug up tight enough to hold the terminal. Just make sure the terminal cannot be turned by hand before replacing the rear interior panel. 3342
by: gregory w.01/15/2012
Is this review helpful?
The product was exactly what I paid for. It was very easy to install and came with complete information on how to install it.29734
by: Dave Cummins12/16/2011
Is this review helpful?
The product, instructions and your service were all GREAT! Installing the wiring was a piece of cake, and only took about fifteen minutes, with most of that time used to undo a poor wiring job a previous owner of my van had done. The wiring works great, so now I can hook up my boat trailer, and go do some fishing. The next time I need anything auto related. I'll contact etrailer. Thanks again, Dave 28208
by: Jeff08/23/2011
Is this review helpful?
Wiring was easy to install. Very good quality and fit just right.22582
by: Dave D06/28/2011
Is this review helpful?
Good product, One note on a 2000 olds silhouette with the air compressor you have to cut the plugs off and attach it to the factory harness you should have with your van, at least according to the olds dealer. 18057
by: Larry Piper06/07/2011
Is this review helpful?
The installation video was great and the harness went right in easy. Thank You16379
by: thomas s05/27/2011
Is this review helpful?
The kit was the quickest way to wire a vehicle ever. perfect fit15579
by: Tom E05/16/2011
Is this review helpful?
The product worked great, and the delivery was very fast! Thanks for the fine service.14365
by: Bernie B.05/10/2011
Is this review helpful?
Product is of good quality. install is very easy.13254
by: john03/30/2008
Is this review helpful?
easy it was so easy evan a cave man can do it717
Ask the Experts about this Tow Ready Custom Fit Vehicle Wiring
Do you have a question about this Custom Fit Vehicle Wiring?
Related Products...
Installation Details
