T-One Vehicle Wiring Harness with 4 Pole Trailer Connector

Tow Ready Custom Fit Vehicle Wiring - 118324

Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese

• Provides a 4-pole flat trailer connector for the vehicle
• Quick and Easy
• No Cutting, Splicing or Taping
• Just Plug in the T-One Connector and You're Ready to Tow
• Solid One Piece Construction
• 16 Gauge Bonded Wire w/ 4-Flat Plug
• "Factory" Appearance
• Simple Do-It-Yourself Instructions on Every Package

Can be used with 5-pole, 6-pole or 7-pole adapters.

Installation: Connection point is located in jack storage compartment on drivers side of vehicle. The 4-pole trailer connector will be stowed in the jack storage compartment when not in use.

Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.

Warning:

Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:

• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)

Read vehicle's owners manual and instruction sheet for additional information.

This Product Fits The Following Vehicles

1991 - 1994 Mazda Navajo

1991 - 1994 Ford Explorer 2 and 4 Door

Ask the Experts about this Tow Ready Custom Fit Vehicle Wiring
Do you have a question about this Custom Fit Vehicle Wiring?

• Installation of T-1 Vehicle Wiring Harness on 1991 Ford Explorer
  
• The T-1 Connector would plug inline into the wiring harness leading to the rear tail light assemblies. This harness is located in the jack storage compartment. Locate the wiring harness connector, and disconnect it. One end of the T-1 harness would plug into each end of the harness you have disconnected. This will create a bit of slack in the wiring harness.
  view full answer...


• Tow Ready Wiring Harness Recommendation for a 1994 Ford Explorer
  
• The Tow Ready Custom Fit Vehicle Wiring # 118324 that you referenced would be the correct trailer wiring harness for your 1994 Ford Explorer. If you were to install this product on your vehicle it would provide you with a functioning 4-way that would work in replacement of the factory 4-way you have that is not functioning correctly. I attached installation instructions for this product for you to check out also. The first thing I would check would be to see if the towing package fuse coul
  view full answer...