T-One Vehicle Wiring Harness with 4 Pole Trailer Connector

Tow Ready Custom Fit Vehicle Wiring - 118315

Tow Ready T-One Vehicle Wiring Harness by Draw-Tite, Hidden Hitch and Reese

• Provides a 4-pole flat trailer connector for the vehicle
• Quick and Easy
• No Cutting, Splicing or Taping
• Just Plug in the T-One Connector and You're Ready to Tow
• Solid One Piece Construction
• 16 Gauge Bonded Wire w/ 4-Flat Plug
• "Factory" Appearance
• Simple Do-It-Yourself Instructions on Every Package

Can be used with 5-pole, 6-pole or 7-pole adapters.

Installation: Connection point is located drivers side rear frame rail near the bumper.

Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.

Warning:

Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:

• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)

Read vehicle's owners manual and instruction sheet for additional information.

This Product Fits The Following Vehicles

1988 - 1998 Chevrolet C/K Series Pickup 1500 Series

1988 - 1998 GMC C/K Series Pickup 1500 Series

1988 - 2000 Chevrolet C/K Series Pickup 2 Dr. Extended Cab only

1988 - 2000 GMC C/K Series Pickup 2 Dr. Extended Cab only

1988 - 2000 Chevrolet C/K Series Pickup 8 ft. Bed only

1988 - 2000 GMC C/K Series Pickup 8 ft. Bed only

1988 - 2000 Chevrolet C/K Series Cab and Chassis All Models

1988 - 2000 GMC C/K Series Cab and Chassis All Models

1988 - 2000 Chevrolet C/K Series Pickup All Models

1988 - 2000 GMC C/K Series Pickup All Models

1988 - 2000 Chevrolet C/K Series Pickup All Models with 10 inch Deep Drop Bumper

1988 - 2000 GMC C/K Series Pickup All Models with 10 inch Deep Drop Bumper

Customers Who Purchased This Custom Fit Vehicle Wiring Also Bought...

Ask the Experts about this Tow Ready Custom Fit Vehicle Wiring
Do you have a question about this Custom Fit Vehicle Wiring?

• Connection Point for T-One Vehicle Wiring Harness 4-Way Trailer Connector # 118315, 1998 GMC Pickup
  
• The T-One Vehicle Wiring Harness with 4 Pole Trailer Connector, # 118315, is a fit for your 1998 GMC pickup. The connection point could be difficult to find unless you know where to look. What you are looking for is a connector that leads to your taillight wiring. It should be located along the driver side frame rail near the bumper. I have included a link to the installation instructions below.
  view full answer...


• Determining the Function of a Wire Labeled YEL FEED BRK SW on a 1994 Chevy C/K2500
  
• The wire you are referring to is probably the center high mount stop light wire or CHMSL. This wire would be used for a third brake light function for example on a camper shell. You can test it by using a circuit tester like the Quickee # 3808. If the wire shows a signal only when the brakes are pressed, and not when the turn signals are on or flashers are engaged, then it is the CHMSL. If it does show a signal with the blinkers and flashers then it is a taillight brake light wire that also
  view full answer...