Wiring Harness Installation - 2004 Nissan Xterra - Video
Tow Ready Vehicle Wiring Harness Tow Package Replacement by Draw-Tite, Hidden Hitch and Reese
Designed for models equipped with a factory installed tow package.
- Provides a 4-pole flat trailer connector for the vehicle
- Quick and Easy
- No Cutting, Splicing or Taping
- Just Plug in the Connector and You're Ready to Tow
- Solid One Piece Construction
- 16 Gauge Bonded Wire w/ 4-Flat Plug
- "Factory" Appearance
- Connector is Equipped with a Circuit Protected Taillight Converter
- Simple Do-It-Yourself Instructions on Every Package
Can be used with 5-pole, 6-pole or 7-pole adapters.
Installation: Connection point is located under the vehicle, behind the rear bumper on the passenger side. The 4-pole trailer connector will be stowed under the vehicle close to the trailer hitch. A mounting bracket is recommended.
Tech Tip: It is always a good idea to apply a small amount of grease to all electrical connections to help prevent corrosion.
- Warning:
- Overloading circuit can cause fires. Do not exceed lower of towing manufacturer rating or:
- Max. stop/turn light: (7.5 amps)
- Max. tail lights: (7.5 amps)
Read vehicle's owners manual and instruction sheet for additional information.
Replaces # 18244
Reliability
Performance
Ease Of Use
Installation
Cost-Benefit
plug and play
mikepropaintball from North Port, Florida
quality better than factory original, installation was plug and play at it's best!!!!
Instructions
