Curt Trailer Hitch Receiver with Drawbar - Custom Fit - Class I - 1-1/4"

Curt Trailer Hitch - 11749

Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar, pin and clip are included.

Features:

• Custom fit is designed specifically for your vehicle
• Precision, robotic welding maximizes strength and improves fit
• WeatherTite construction prevents interior rust by sealing main body
• Bolt-on installation - no welding required
  • Complete hardware kit and installation instructions included
• Lifetime technical support from the experts at etrailer.com
• Gloss black powder coat finish over steel resists corrosion
• Sturdy, square-tube design
• Drawbar, pin and clip included
• Made in USA

Specs:

• Receiver opening: 1-1/4" x 1-1/4"
• Rating: Class I
  • Maximum gross trailer weight: 2,000 lbs
  • Maximum tongue weight: 200 lbs
• Limited lifetime warranty

Note: All non-trailer loads - bike racks, cargo carriers and so forth - should be supported with stabilizing straps. Failure to properly support these loads will void your hitch warranty from Curt.

etrailer.com Technical Support

At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.

11749 Curt Class 1 Trailer Hitch Receiver

This Product Fits The Following Vehicles

1998 - 2005 Mazda Miata

Ask the Experts about this Curt Trailer Hitch
Do you have a question about this Trailer Hitch?

• Is Trimming or Modification Required to Install Curt Trailer Hitch 11749, 1998 to 2005 Mazda Miata
  
• The Curt Class I Trailer Hitch, # 11749, should not require any rear fascia trimming or modification. The instructions do not list any steps for trimming, modification, and there are no notes regarding the receiver touching the rear fascia. I have included a link to the installation details for reference. I f you needed to trim the fascia, you can use a sharp utility knife (like a box cutter), score the area that needs to be trimmed, and in many cases, wiggling the piece back and forth will p
  view full answer...