Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Rating: 
1 reviews
Code: 11331
Retail:$242.38
Price:$134.95
Shipping Weight: 25 pounds
Shipping SpecialPerfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar, pin and clip are included.
Features:
Specs:
Note: All non-trailer loads - bike racks, cargo carriers and so forth - should be supported with stabilizing straps. Failure to properly support these loads will void your hitch warranty from Curt.
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Video of Curt Trailer Hitch Receiver with Drawbar - Custom Fit - Class I - 1-1/4"
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Today were working on a 2010 Chevy Aveo.Were gonna install a Kurt Hitch part number 11331.Here are a couple of measurements that will assist you in selecting accessories for your new hitch. From the center of the pin hole to the outermost part of the bumper is 5 inches. From the top of the receiver tube to the ground is 13 inches. Now lets go ahead with the installation.First we need to gain access to the trunk of the vehicle. With access to the trunk, were gonna need to remove the rear threshold. Weve got two plastic fasteners, well do this first.
Then we can get underneath the threshold, gently pry it up, set it over to release the fasteners in the sheet level. Well remove the threshold, set it out of the way for reinstall later. There are two plugs that we need to remove next we got one here and here. Our hitch is gonna have a total of three fastener points. For the two fastening points, were gonna remove the plugs and the tow hook here.
Next, Im gonna go ahead and put my hardware in place for the tow hook. Now we can raise our hook into position and install the fastener in the tow hook to hold it in place. Im just gonna install this finger tight until I get all my fasteners in position. Now Ill go ahead and get back into the trunk and install our bolt and block.With our carriage bolts and blocks installed, I can now go ahead and get back under the vehicle and install the French nuts. There is the install of our French nuts for our carriage bolt and block on our passenger side.
Ill repeat the same process for the one on the driver side.With all of our hardware installed, now we can go ahead and tighten them down.With all of our fasteners tightened down, we can go ahead and torque to specifications as indicated in the instructions.With our interior reassembled, that completes the installation of our Kurt Hitch part number 11331 on the 2010 Chevy Aveo.
2007 - 2008 Pontiac Wave 4-Door
2007 - 2011 Chevrolet Aveo 4-Door Sedan
Customers Who Purchased This Trailer Hitch Also Bought...
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
by: Pete R-S04/14/2009
Is this review helpful?
Fantastic product. I have nothing but good things to say about this hitch. Installation was very simple, everything lined up properly and it only took about 15-20 minutes to get it set up ...I'm an artist with extremely limited mechanical experience so, well, it is an easy install. I bought it to support a hitch-mounted bike rack and it is serving its purpose perfectly well. Worth every penny.1741
Related Products...
Installation Details
