State of Texas Flag 2" Trailer Hitch Receiver Cover

Video Transcript for Texas Flag Trailer Hitch Cover Review

Today we are going to show you the state of Texas Flag 2-Inch Receiver Hitch Cover, part number 034092101109. As you can see here, the tube cover itself is a depiction of the Texas flag. And this is an alloy material with enamel that has been put inlay into the shape itself. I will show you the back side of it. This comes with a foam gasket to help it fit on the receiver hitch a little bit tighter. It also comes with two different wire forms here. These wire forms adjust the tube cover to match different variants in the hitch pin. Some are farther back in the hitch tube than others. As you can see, there is only a short length here and a long length here. And you only use one at a time and they fit into these tabs sticking out. The tabs themselves have different lengths where the holes are. This tab here, if you can see, is towards the edge. And on this one over here, it is a little bit closer down towards the bottom. Use that in conjunction with the wire forms to get the best fit possible on your hitch.

Alright, we will go ahead and install it and show you how it looks on a typical 2-inch receiver hitch. To install this, make sure the wire form goes in in the corners of the hitch. Go ahead and press it into place. And you will have to press the foam on some models to make sure it has a tight fit. Again, some will fit tighter than others. In this case you have to push in a little bit and then put your pin all the way through. And then you clip. You could also use a locking pin, too, if your have one. And it is ready to go. Alright, and that covers the review of the state of Texas Flag 2-Inch Receiver Hitch Cover.