2008 Toyota RAV4 Roof Rack by Rhino Rack

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.

Video Transcript for Rhino Rack Roof Rack Installation - 2008 Honda Odyssey

Today on this 2008 Honda Odyssey with factory raised side rails we will be installing a Rhino Rack roof rack part number SXB3. We already have our crossbar assemblies put together so we are ready to go ahead and mount them to our vehicle. We will take our front crossbar assembly and lay it in place on top of our side rails. When positioning the front crossbar we need to make sure that our overhang is even on both the drivers side and passenger side. Once we have done that we need to ensure that our new crossbar is running perpendicular to our factory side rails. To do this we are going to position the clamps right up against the seam between our side rail and our side rail foot mount on both sides. Next we are ready to tighten the system down. We will use the included allen wrench and tighten down the bolts inside the crossbars. We will move back and forth between from passenger side to driver side to make sure we tighten down the system evenly.

With our front bar assembly tightened down we are ready to position and tighten down the rear. We will also need to make sure that the rear bars runs parallel with the front bar. To do this measure from the center of the front bar to the center of the rear bar. This measurement is called your crossbar spread. If the spread is even on both sides then we know that the back bar is parallel with the front. With our rear crossbar positioned we will repeat the same tightening procedure that we used for the front. The last thing we need to install are our locking endcaps. From the top of our factory side rail to the top of our new crossbar we have added about 1-3/4 inches. And that does it for the Rhino Rack roof rack on our 2008 Honda Odyssey with factory raised side rails.