2012 Jeep Grand Cherokee Lamp Guards

If you were to install the EcoHitch #306-X7239 on your 2017 Ford Fusion then you would have to permanently remove the plastic underbody panel as you can see from the attached photo which is directly from the instructions. I have also attached a…

The Yakima Replacement Hitch Bolt and Clip for Yakima HoldUp Hitch Mounted Bike Carrier, part #Y8890200, is a 5/8 inch bolt. The size wrench you would use to install or remove this bolt is 15/16 inch.

Yes, the etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates #e47ZR would have enough adjustability between the 1-1/2" shank rise/drop and the 3" of tilt to meet your 4" difference. I've attached a video below where Dave will…

The Blue Ox Acclaim Non-Binding Tow Bar #BX4330 is compatible with Blue Ox base plates that are between 23" and 30" apart on center. Since you're measuring 34" on center I recommend checking out the etrailer SD Non-Binding Tow Bar…

The 16 inches of height that the Yakima SkyBox NX 16 Cargo Box #Y95AV that you referenced would be the height above the crossbars of your 2005 GMC Yukon Denali. I attached a review video for this cargo box for you to check out also.

Before deciding on a trailer to tow with your 2014 Ford Fusion, knowing the towing limitations of your vehicle will be an important factor. In the owner's manual for the 2014 Fusion, it lists the maximum trailer weight of all the powertrain…

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the floor of the truck bed and 1 inch…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I recommend using the Fastway e2 Weight Distribution #FA92-00-0800 for your 7x14 Interstate Loadrunner tandem axle trailer. This hitch is rated for trailers up to 8,000lbs with a tongue weight between 400-800lbs. If your unloaded tongue weight is…

The B and W Turnover Ball hitch part #BWGNRK1309 is a confirmed fit for your 2015 Ram 1500 with an EcoDiesel engine. Since your truck has a such a short bed you are going to want to use the offset adapter part #BWGNXA4685 as well. Hopefully the nose…

The etrailer Trailer Hitch Receiver #e98906 that you referenced has been confirmed as a fit for your 2013 Volkswagen Tiguan. As far as hitch installs go this is the easiest one to install. It is rated 3 out of 10 on the difficulty scale. Basically,…