bing tracking image

Best Jeep Commander Tow Bars

change vehicle


Tow Bar Videos

RoadMaster Blackhawk 2 All Terrain Tow Bar Installation - 2010 Jeep Commander

Today on our 2010 Jeep Commander we're gonna be taking a look at the Roadmaster Blackhawk 2 all-terrain non-binding tow bar, as part of our flat two setup.There are five main components for flat tow setup for the 2010 Jeep Commander. You have your base plate, you have your diode wiring kit, you have your braking system, your tow bar, and your safety cables.Here we have Roadmaster's Blackhawk 2 all-terrain tow bar. What a tow bar does is it gives you a solid connection between the base plate on your Jeep and your RV. This specific tow bar is gonna come with this quick disconnect bar. Depending on which base plate you choose, you may or may not need to use this bar.As you can see here, we have our tow bar connected to the back our RV and to our Jeep. This tow bar is gonna have a 10,000 pound weight capacity and it's gonna be a non-binding tow bar, which gives you the ability to disconnect your vehicle on un-level ground.



Roadmaster Base Plate Installation - 2006 Jeep Commander

Today on 2006 Jeep Commander, we're going to install a base plate kit from Roadmaster, product number RM-1427-1. The first thing we're going to do is go ahead and open up the hood and remove six plastic fasteners across the top and the grill. To remove the grill, we simply pull up in the center. You may pick up on the side a little bit and it unsnaps. Now, we're going to remove the four fasteners that connect the bumper, cover, to the core support. Alright, we'll remove the tubes, bolts attaching the fascia to the radiator support.



Roadmaster Tow Bar Wiring Kit Installation - 2006 Jeep Commander

Today is 2006 Jeep Commander. Were going to install part number RM-154 from Roadmasters. First thing were going to do is route our cable from front to rear. One end of the cable, youre just cut it off and run towards the back, and it will save the other four pole for the in front of the car. Run our wire to the back of the vehicle, now well go ahead and remove the taillights, and were going to pull wires from the bottom up. Well just kind of unclip our wire harness here and then unplug the wire harness from the light.





Jeep Commander Tow Bar Questions