Front/Rear Hanger for Double-Eye Springs - 1-1/2" Tall - 9/16" Bolt Hole

Redline Trailer Suspension - 115917

Hanger can be configured to work in either the front or rear position to suspend your double-eye leaf spring.

Features:

• Configured for use as front or rear hanger
  • If used as rear hanger on single-axle systems, use 93003-3X (sold separately)
• Provides attachment point for leaf spring
  • Hanger suspends spring from trailer frame
• Fits 1-3/4" wide double-eye springs with 9/16" diameter eyes
• Works with 9/16" diameter bolt (sold separately)
• Weld on application

115917 Front or Rear Hanger for Double Eye Springs - 1-1/2" Tall - 9/16" Bolt Hole

Customers compare 115917 to these similar products

4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles$20.95

3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles$14.99

Rear Hanger with Bushing for Single Axle Trailer Suspensions with 1-3/4" Double Eye Springs$4.89

Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 7/8" Rear$18.95

Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole$3.69

Customers Who Purchased This Trailer Suspension Also Bought...

Shackle Bolt with Locknut for Double-Eye Springs - 3" Long $3.08

Shackle Strap - 2-1/4" Long $0.70

Shackle Strap - 2-5/8" Long $0.65

Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long $3.08

Rear Hanger with Bushing for Single Axle Trailer Suspensions with 1-3/4" Double Eye Springs $4.89

Ask the Experts about this Redline Trailer Suspension
Do you have a question about this Trailer Suspension?

• Where to Install Shackle Straps and How to Determine Axle Position When Building an ATV Trailer
  
• For a 3,500 Dexter Straight axle the springs should be placed between 16 and 18 inches on center from the hub face (flat area the wheel mounts against). Placement of the spring centers in any other position will reduce the axle capacity. If you are using a different brand of axle you will need to contact the axle manufacturer for the full capacity spring center dimensions. If you are using double eye springs then the shackle straps will be located at the rear of the springs. The top bolt and
  view full answer...


• What Could Cause a Homemade Trailer to Sway
  
• When you are calculating the 40/60 split of weight on a trailer you are going to want to consider the entire length of the trailer. There could be a lot of reasons for trailer sway but your best defense against it is proper loading of the trailer. Heavier items should be at the bottom and the load should be even side to side. If the tongue weight is too low or too high, that could also cause sway. Typically, the tongue weight should be 10 to 15 percent of the gross trailer weight when loaded
  view full answer...


• In What Orientation are Trailer Suspension Hangers Installed
  
• Based on the picture you submitted you would want to rotate the hanger that is in your hand 90 degrees clockwise and weld the flat portion with the 2 holes in it to the bottom of your trailer frame. So yes, you are correct in how you thought it should be welded on. I attached an FAQ article on trailer suspension for you to check out.
  view full answer...