Rear Hanger for 1-3/4" Slipper Spring

Redline Trailer Suspension - 115706S

Used on 1-3/4" Wide "WI" series slipper springs with 9/16" Spring Eye I.D.

Customers compare 115706S to these similar products

2-Leaf Slipper Spring for 1,000-lb Trailer Axles$14.99

3-Leaf Slipper Spring for 1,500-lb Trailer Axles$17.95

Single-Axle Trailer Hanger Kit for 1-3/4" Slipper Springs - 1-1/2" Tall Front$10.99

Front/Rear Hanger for Double-Eye Springs - 1-1/2" Tall - 9/16" Bolt Hole$2.89

4-Leaf Slipper Spring for 2,000-lb Trailer Axles$19.95

Customers Who Purchased This Trailer Suspension Also Bought...

Front/Rear Hanger for Double-Eye Springs - 1-1/2" Tall - 9/16" Bolt Hole $2.89

Shackle Bolt with Locknut for Double-Eye Springs - 3" Long $3.08

2-Leaf Slipper Spring for 1,000-lb Trailer Axles $14.99

3-Leaf Slipper Spring for 1,500-lb Trailer Axles $17.95

Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long $2.98

Ask the Experts about this Redline Trailer Suspension
Do you have a question about this Trailer Suspension?

• Mounting a Rear Slipper Spring Hanger
  
• When welding a metal part to another piece of metal, it is always best to have as much metal touching between the two parts. With this in mind, the majority of customers will weld the top of the hanger to the frame of the trailer, leaving the side with the open portion facing the ground. This will be the same for the rear slipper spring hanger, part # 115706S.
  view full answer...


• Will Slipper Spring Hanger # 115706S Work with a 2 or 3 Slipper Spring
  
• As long as the slipper spring you have has a width of 1-3/4 inches and the spring eye diameter is 9/16 of an inch this Rear Hanger for Slipper Spring # 115706S would work well for you. I attached an FAQ article on slipper spring trailer suspension for you to check out also.
  view full answer...


• How to Determine where to Place Slipper Spring Hangers for Boat Trailer Suspension
  
• When replacing springs on a trailer, you will want to measure the exiting springs with no load on them first. With these measurements, you can find the best replacement springs based on the axle capacity. The 3-Leaf Slipper Spring, # WIE3, is designed for 1,500 pound trailer axles, so you would need two of them for one 1,500 pound axle. The capacity of just one spring is 750 pounds. The measurements are provided on the product page. If you determine that # WIE3 is the correct spring for your
  view full answer...