Shelby Weld-On Trailer Jack, Sidewind Swivel with 8" Wheel - 1,500 lbs.

Shelby Trailer Jack - 5876A8

Shelby swivel jack is a bolt-thru design (called OSD) with the jack tube offset from the bolt to allow easier access for mounting. Also engineered with a 6 degrees camber to keep the jack centered under the tongue. Zinc coated with "supersealer" for added corrosion resistance. Fits 3" to 5" tongues. The new "Diamond Series" wheel provides added durability to the advanced engineering design of the OSD jack family.

Jack swivels parallel to the trailer tongue for towing, rotates into position for lifting.

• 1,500 lbs. capacity
• 10" lift
• 8" Wheel
• Weld-On Bracket Type
• 16-1/2" bracket height
• 24-3/4" retracted height

Customers compare 5876A8 to these similar products

Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs$39.95

Shelby Bolt-On Trailer Jack, Sidewind Swivel with 8" Wheel - 1,500 lbs.$95.95

Fulton Bolt-Thru Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs$49.95

Fulton Bolt-Thru Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,500 lbs$84.95

Pull Pin, Easy Swivel Trailer Jack with 8" Wheel - Sidewind - 1,500 lbs. by Dutton-Lainson$81.95

Ask the Experts about this Shelby Trailer Jack

• Mounting Plate Dimensions for a Shelby Weld-On Trailer Jack # 5876A8
  
• I went out into our warehouse and measured the mounting plate of a Shelby Weld-On Trailer Jack # 5876A8 and found that it measures 2-1/8 inches from the center bolt to the stop pin hole from center to center. Check out the picture I attached to see this measurement.
  view full answer...