Atwood Trailer Jack - 80515
Atwood Power Jacks use a powerful 12 volt weather resistant DC motor with slip resistant clutch which is protected by a rugged polyethylene cover. The jack is permanently lubricated and features a detachable foot pad on a high strength, zinc plated and black powder coated tube. The deluxe model also features a bright, built-in light for illumination of the trailer tongue and tow vehicle after dark.
- Capacity: 2,500 lbs
- Lift: 14"
- Bracket Height: 10-1/8"
- Retracted Height: 24-7/8"
- Rate of Travel: 10" per minute
Customers compare 80515 to these similar products
Customers Who Purchased This Trailer Jack Also Bought...
Replacement parts available for this product
Ask the Experts about this Atwood Trailer Jack
- Fitting Atwood Powered Jack 80515 onto Trailer Tongue Jack Plate
- Trailer tongue jack plates and jacks use a standard bolt pattern so that there is complete compatibility. The part manufacturers often elongate their bolt holes to allow some wiggle room. I measured one of these in our warehouse as best as I could, the measurement is right at 3-1/4 inch center to center on this jack.
view full answer...
- What is the Lift Capacity of Atwood Powered Trailer Tongue Jack # 80515
- Yes, the Atwood Deluxe Power Trailer Jack W/ Cover and Foot, item # 80515, should work fine on your trailer. You will need to weigh the tongue weight of your trailer to be sure, but you should not have more than 875 pounds of tongue weight. The # 80515 powered jack is able to lift and support up to 2,500 pounds.
If you are using a weight distribution system, you may want to consider the heavier rated jack, item # BD500185. With the higher 4,000 pound rating you will have the capacity to use t
view full answer...
- Availability of Replacement Lens Cover for the Atwood Model 2500 Powered A-Frame Jack Part 80515
- A replacement lens cover for the Atwood 2500 Jack, part # 80515 is available. The lens for this jack is part # 87591SP, and can be seen by using the provided link.
view full answer...
- Can I Use Atwood Jack, # 80515, With 2,500 Lbs. Capacity For Trailer With 875 Lbs. Tongue Weight
- The 2,500 lbs. capacity is the maximum weight that the Atwood Trailer Jack, # 80515, can lift and is the lowest weight capacity I have available in a powered jack. If you are mounting the jack on the trailer tongue towards the coupler you can go by the trailer tongue weight of your trailer fully loaded.
If you will not be lifting over 2,500 lbs. and you have a maximum tongue weight of 875 lbs. the Atwood Trailer Jack, # 80515, will work fine on your application.
If you are not going to be
view full answer...
- Comparing of the Atwood and Bulldog Electric Trailer Jacks
- The Atwood Power Trailer Jack with Cover and Foot, item # 80515, has a lift speed of 15 inches per minute. It also has a lift range of 14 inches. This jack has been around for a very long time and is very dependable. The wiring on this jack is slightly larger than the wiring on the Bulldog model. It is rated for 2,500 pounds.
The Bulldog Powered-Drive Trailer Jack - Drop Leg - A-Frame - 17 inch Lift - 4,000 lbs has a lift speed of 13 inches per minute and 1 amp draw unloaded. Loaded to capac
view full answer...
- How To Manually Raise The Atwood Power Jack # 80515 And Does It Have a Fuse
- If you have the Atwood Short, Deluxe, Heavy Duty or Marine jack like the Atwood Jack, part # 80515, it will have an alignment tube opening that will be used to manually control the raising or lowering of your jack. You would place the manual override handle, part # 87891, that is included with the jack, into the opening and crank the handle clockwise to raise the jack or counterclockwise to lower the jack.
If you have the Atwood Standard or Lightweight jack it will not have a opening for a m
view full answer...
- Is the 2,500 lb Capacity of the Atwood Power trailer Jack for Tongue Weight or Total Trailer Weight
- 2,500 lbs is the vertical lift capacity of the jack, so as long as your trailer tongue weight is less than 2,500 lbs you will be good to go. A 19 foot travel trailer will not typically have a tongue weight approaching 2,500 lbs so I would venture to say that the Atwood Deluxe Power Trailer Jack, # 80515, would be a good choice for your trailer.
view full answer...
- Fuse Needed for Atwood Deluxe Power Trailer Jack # 80515
- The power wire of the Atwood Deluxe Power Trailer Jack, part # 80515 should already be protected by a 30 amp inline fuse.
view full answer...
- Does the Atwood Deluxe Power Trailer Jack Come with a Manual Jack Handle
- Yes, a manual handle does come with the Atwood Deluxe Power Trailer Jack # 80515. We also sell the handle as a replacement part. Check out part # 87891 to see what the handle looks like.
view full answer...
- Is the Atwood Deluxe Power Trailer Jack Waterproof
- In order for something to be considered waterproof it needs to be able to be submerged underwater for a length of time without allowing any water to seep in. The Atwood Deluxe Power Trailer Jack # 80515 that you referenced is considered weather proof and under normal circumstances would not get damaged by rain. If this was going on a boat trailer you would not want to submerge the jack during launching.
view full answer...
