Curt Trailer Hitch Receiver with Drawbar - Custom Fit - Class I - 1-1/4"

Curt Trailer Hitch - 11765

Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar, pin and clip are included.

Features:

• Custom fit is designed specifically for your vehicle
• Precision, robotic welding maximizes strength and improves fit
• WeatherTite construction prevents interior rust by sealing main body
• Bolt-on installation - no welding required
  • Complete hardware kit and installation instructions included
• Lifetime technical support from the experts at etrailer.com
• Gloss black powder coat finish over steel resists corrosion
• Sturdy, square-tube design
• Drawbar, pin and clip included
• Made in USA

Specs:

• Receiver opening: 1-1/4" x 1-1/4"
• Rating: Class I
  • Maximum gross trailer weight: 2,000 lbs
  • Maximum tongue weight: 200 lbs
• Limited lifetime warranty

Note: All non-trailer loads - bike racks, cargo carriers and so forth - should be supported with stabilizing straps. Failure to properly support these loads will void your hitch warranty from Curt.

etrailer.com Technical Support

At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.

11765 Curt Class 1 Trailer Hitch Receiver

This Product Fits The Following Vehicles

2000 - 2005 Audi TT Coupe and Convertible

Ask the Experts about this Curt Trailer Hitch
Do you have a question about this Trailer Hitch?

• Does the Curt Class I Trailer Hitch # 11765 Require Bolting to the Exterior of the Audi TT
  
• The Curt Class I Trailer Hitch, item # 11765, does not require bolting or attaching anything to the exterior, visible, portion of the vehicle. There are 5 bolts that secure the hitch, under the vehicle, to the driver and passenger side frame rails. We have the trailer hitch installation instructions (see link) online for you to review. Some items you may need to complete your Class I towing setup are listed below. Hitch Ball 1-7/8 inch, item # 19256 Hitch Ball 2 inch, item # 19258 Hit
  view full answer...


• What is the Ground Clearance with Curt Trailer Hitch, # 11765 Installed on a 2004 Audi TT Quattro
  
• I spoke with my contact at Curt about trailer hitch # 11765. He stated that when the hitch is installed the receiver tube, which will be the lowest point, will be about 1-3/4 inches to 2 inches below the bottom of the rear fascia. What you can do is park your 2004 Audi TT on level ground and measure up from the ground to a point that is about 2 inches below the rear fascia and that is where the bottom of the receiver will be. I have included a link to the installation details for this hitch for
  view full answer...