Atwood Trailer Coupler - 81911
Atwood A-Frame Trailer Coupler
- Ball Size - 2-5/16"
- Designed for 50 degree A-Frame Tongue
- Painted Finish
- 10,000 lb Capacity
Customers Who Purchased This Trailer Coupler Also Bought...
Ask the Experts about this Atwood Trailer Coupler
Do you have a question about this Trailer Coupler?
- Are Parts Available to Replace the Latch on the Atwood # 81911 2-5/16 Inch Ball, A-Frame Coupler
- I spoke with my contact at Atwood and there is not a repair kit available for the Atwood # 81911, 2-5/16 inch Ball, A-Frame Tongue coupler. If this coupler is damaged the complete unit will need to be replaced.
view full answer...
- Can Atwood A-Frame Trailer Coupler # 81911 be Locked With a Coupler Latch Lock
- I went out to the warehouse and pulled both couplers, # 80101 and # 81911, to examine them more closely. A traditional lock for the latch, like # 3008, will not work on his original coupler # 80101 because of that unique design that you have mentioned.
But, it will work on the other coupler, # 81911. I tested it to be sure and the coupler latch can not operate to remove it from the ball with the lock in place.
view full answer...
- Hole Size for Electric Trailer Jack Installation on the Atwood Coupler # 81911
- I went out to the warehouse and pulled the Atwood Trailer Coupler, # 81911, and the center installation hole in the coupler is 2-1/4 inches inside diameter. The bolt holes around the hole are 3-1/8 inches on center at the back of the coupler and 3 inches from the back two bolt holes to the front bolt hole. See photo attached for clarification.
I also pulled the Bulldog Powered-Drive Trailer Jack, # BD500186, and the Stromberg Carlson Electric Trailer Jack, # JET-3500. The Atwood coupler insta
view full answer... 
