Connect your towed car's lighting system to your RV's to get the brake lights and turn signals required for towing. Designed for use with Toyota Tacomas that have separate brake and turn signals. 4-Pole flat loop and wiring converter included.
Note: If your RV has separate brake and turn signal lights, you do not need to install the included tail light converter. However, you will need to replace the 4-way Toyota Tacoma-side connector with one that is capable of carrying the separate signals.
The diagram below shows the installation of the 6-diode tail light wiring kit on a towed Toyota Tacoma (or dinghy) that has separate turn signals (typically amber) and red brake lights. This kit will most often be used with a motor home that operates off of a 2-wire system wherein the brake lights do the flashing for the turn signals. The included tail light converter (118158) is used to convert the combined brake and turn signal lights to separate ones to match those of your towed Toyota Tacoma.
Average Customer Rating: 4.5 out of 5 stars (4 Customer Reviews)
by: Rich L.03/05/2013
The diodes and wiring are good and worked well. But the 118158 converter produced a 3.5 volt drop such that the brake lights were as dim as the tail lights. And when a turn signal was triggered the brake lights dimmed even further. I ended up stringing a separate brake wire through the car and re-wiring my truck with a 5-wire connector.68855
by: Jerry B.08/04/2013
Prompt deliver of product. We haven't gotten this part of our project installed, we are still watching YouTube videos and other info on procedure. Had very little difficulties installing base plate on our 2013 CRV this should go well also. Our lights are a little more complicated but once we figure out how to actually wire to them every thing we've learned so far is very straight forward.93187
by: Rich B.06/02/2012
This harness was an excellent choice. It took about an hour and fifteen minutes to install. Everything is spelled out for you in the instructions and if all else fails, watch the online video. The hardest thing was removing the tail light on the Sportage. I has a ball joint connection that forces you to pull harder than you think you should. I was afraid I would break the light. But it popped out and the rest was easy. Very complete and works great! The connections fit like factory. Very Pleased.42472
by: RON H.07/29/2013
I PUT YOUR PRODUCT 154-792-11858 ON MY 1988 SUZUKISAMURIA AND IT WORKED GREAT. I WENT WITH OPTION 2, MORE WORK BUT WORKED GREAT. THANK YOU VERY MUCH.92269
Ask the Experts about this etrailer Tow Bar Wiring
Do you have a question about this Tow Bar Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.Let us know if anything is missing or if you have any questions.